Weslo WLTL29820 user manual Touch the Right Handrail 94 to discharge any static

6.Insert the Battery Cover (12) into the Console Base (87), with the hinges in the position shown. The Battery Cover should pivot down, away from the Console Base.

7.Hold the Console (11) near the Console Base (87).

Touch the Right Handrail (94) to discharge any static.

Locate the two wires in the Wire Harness (53) that have L-shaped connectors on the ends. Press the connectors onto the two tabs on the switch shown in inset drawing 7a. Connect the other two wires in the Wire Harness to the back of the Console (87) in the locations shown by the arrows in drawing 7. If the connectors do not fit together easily, rotate them and then connect them.

Securely tighten each plastic tie to prevent the Wire Harness from slipping. Cut off the ends of the plastic ties.

8.Set the Console (11) in the Console Base (87). Cover the Wire Harness (53) with the Wire Cover (10), and route the Wire Harness out of the hole in the side of the Wire Cover. Attach the Wire Cover to the back of the Console Base with two 3/4” Screws (5). Make sure that no wires are pinched before you attach the Console to the Console Base.

Tighten four 3/4” Screws (5) into the Console Base (87) and the Console (11). Do not overtighten the Screws.

9.Attach the Storage Latch (66) to the Left Upright (14) with two 3/4” Screws (5).

10.Make sure that all parts used in assembly are prop- erly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill.

6
			87
			Hinges
		12
7
			11
	87		53
		53
	Ties	7a	Tabs
		94
8	10	87	11
53	5
		5	5
9
			14
	66		5

7