DIAGRAM OF THE CONSOLE
Displays
Speed Control
Note: If there is a thin sheet of clear plastic on the face oftheconsole,removeitbeforeoperatingtheconsole.
CAUTION: Before operating the console, read the following precautions.
•Do not stand on the walking belt when turning on the power.
•Always wear the clip (see the drawing below) while using the treadmill. When the key is
removed from the console, the walking belt will stop.
•Adjust the speed in small increments.
•To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console. Put only sealable water bottles in the water bottle holders.
BATTERY INSTALLATION
The console | 12 |
requires two | |
"AA" batteries |
|
(not included). |
|
Alkaline batter- | Batteries |
ies are recom- | |
mended. | 12 |
To install bat- | |
teries, open |
|
the battery |
|
cover (12) |
|
beneath the | Tab |
console as |
|
shown. Press |
|
two batteries into the console. Make sure that the negative
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the power cord is properly plugged in (see page 8).
Step onto the |
| |
foot rails of the |
| |
treadmill. Find | Key | |
the clip attached | ||
| ||
to the key, and |
| |
slide the clip |
| |
onto the waist- |
| |
band of your |
| |
clothes. Next, | Clip | |
insert the key |
| |
fully into the con- |
|
sole. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip as needed.
9