West Bend 6421Z instruction manual Parts Diagram CLEAN BEFORE USING, To Use

Parts Diagram

CLEAN BEFORE USING

1. Open cover by holding cover release buttons in and lifting up. Remove filter screen from spout. Wash filter screen in hot soapy water with dishcloth, rinse and dry.

2. Fill kettle with hot tap water to the 4 cup level. Add a small amount of dishwashing detergent and wash inside of kettle with a dishcloth or sponge. Empty kettle, rinse thoroughly and dry. Replace filter screen by aligning tab(s) on filter with slot(s) in spout area. See Diagram 2 . Push filter down to secure.

CAUTION: To prevent personal injury or electric shock, do not immerse electric kettle, power base, its cord or plug in water or other liquid.

3. Wipe exterior surface of kettle and power base with damp cloth and dry. Your electric kettle is now ready to use.

SPECIAL NOTE: The electric kettle is designed for heating water only. Do not add instant soups, powdered drink mixes, other liquids or foods to kettle for heating, as damage to kettle will occur.

TO USE

1. Open cover and fill kettle with cold water to desired cup level, using the 8-ounce cup markings on kettle as a guide. Water level must be between the MIN and MAX level markings. Do not fill beyond MAX level to avoid water boiling out of spout. Close cover until secured .

2. Place power base on a dry, level surface. With switch in OFF position, place kettle onto power base. Plug cord into a 120 volt AC electrical outlet only. Push switch to ON position. Signal light will glow when kettle is turned on.

2