Whirlpool 110.44832, 200 manual Eeprom onboard the CCU. If there is an error reading

		EEPROM onboard the CCU. If there is an error reading
		this data it will cause this error.
		Potential Causes
		• A power glitch may cause this error. Try unplugging the
		Unit for two minutes to see if that fixes the error.
		• Check CCU.
		Replace failed component.
F15	Motor Control Unit (MCU) error	If the MCU detects multiple resets or errors during a
		wash cycle it will go into this error mode.
		Potential Causes
		• Check Wire Harness connections to the MCU, the
		motor, and Central Control Unit (CCU)
		• Check Drive belt
		• Check MCU
		• Check Motor
		• Check Wire Harness
		Replace failed component.
Sud	SUDS LOCK (Overdose of	The motor control unit senses a suds lock condition by
	detergent detected during the	analyzing the current draw on the drive motor. If “Sud” is
	wash cycle)	displayed a potential suds lock is detected. This may
		signify a bad pump, an extra heavy load, excessive
		detergent, or excessive suds.
		Potential Causes
		• If too much detergent was used, run the unit through a
		Rinse/ Spin cycle then a Normal cycle without adding any
		detergent. This should clear the unit of the excess
		detergent.
		• Check the drain hose and make sure it is not plugged or
		kinked
		• Check Wire Harness connections to the Drain Pump,
		Pressure Switch, and Central Control Unit (CCU)
		• Check / Clean Drain Pump Filter of foreign objects
		• Check Drain Pump
		• Check the Pressure Switch
		• Check CCU
		Replace failed component.
FdL	Door lock error	A Door Lock Error occurs if the door cannot be locked. It
		will try to lock it 6 times before displaying the error.
		Potential Causes
		• Door Lock Mechanism broken or removed from the
		Door
		• Check Door Lock/Switch Assembly
		• Check the wire harness connections to the Door
		Lock/Switch Assembly and Central Control Unit (CCU)
		• Door Lock/Switch Assembly Failure
		Replace failed component.
FdU	Door unlock error	A Door Unlock Error occurs if the door cannot be