Whirlpool 1166073 installation instructions Before you start, Electrical, Wfrhg requirements

Before you start...

Proper installation is your responsibility. Make sure you have everything necessary for correct installation. It is the customer’s responsibility to comply with the installation specifications provided.

Grounded electrical outlet within reach of the power supply cord is required.

See Electrical requirements.F

.8 cm (20”)

Personal Injury/Product Damage

Hazard

l Because of the weight and size of the air conditioner, more than one person is needed to move, lift and safely install it.

l Handle air conditioner with care. Metal fins on front and rear coils are sharp.

l Do Not use the water that collects

inside the air conditioner for drinking

Electrical Shock Hazard

It is the customer’s responsibility:

l To contact a qualified electrical installer.

lTo assure that the electrical installation is adequate and in conformance with Canadian Electrical Code, Part II or latest edition,* and all local codes and ordinances.

Failure to do so could result in fire, electrical shock or other personal injury.

Electrical outlet must be available within reach of power supply cord.

Do not use extension cord.

Important: Observe all governing codes and ordinances.

purposes. It is not sanitary.

l Maintain a firm hold on the air conditioner to prevent it from falling out the window during installation.

l Do Not locate air condiiioner where cabinet front is exposed to a heal source that raises the surface temperature above 48.9% (12O’F).

Failure to follow these instructions could result in personal injury or damage to air condiiioner.

Specific electrical requirements are

Electrical

requirements

Electrical Shock

Hazard

l Electrical ground is required on this

appliance.

l Do Not ground to a gas pipe.

l Do Not modify the power supply

cord plug. If it does not fit the outlet,

have a proper outlet installed by a

qualified

electrician.

l Do Not have a fuse in the neutral or

grounding circuit. A fuse in the

neutral or grounding circuit could

result in electrical

shock.

l Do Not use an extension cord with

this appliance.

l Check with a qualified electrician if

you are in doubt as to whether the

appliance

is properly

grounded.

l Grounding wire must be connected

to grounding screw located in lower

utility

knife

right corner of air conditioner when

air conditioner

is in cabinet.

Failure to follow these instructions

could result in serious injury or death.

L

If codes permit and a separate

grounding wire is used, it is

socket

wrench

recommended

that

a qualified

11.l mm (7/16”) socket &

electrician

determine that

the

6.4 mm

(l/d”)

socket

grounding

path

is adequate.

A single-phase, 60-Hz, AC-only,

electrical supply is required on a

separate circuit. A time-delay fuse or

circuit breaker is required

-

15amp

for

Through-the-wall installations:

models without electric heater and

30-amp for

models

with

electric

heater.

wood preservative

10, #lO

x 25.4

mm

(1”) screws

The fuse size must must not

exceed

the

Parts supplied

for

circuit rating specified on the model

and

serial

label. The model

and

serial

installation:

label

is located

behind

the

front

panel

on the base flange.

2side-

window lock mounting

bracketh a!gles

supkrts

723 2supportsvertical

			I
			nd-	6 lock
			c
		3
#*xlLrf~m	#*x94bmm	11Ox1’9mm f	6 flat	6 nuts
he:!‘&	c3iw	O/4”)	washers
	hex-head,	round-head.

metal scre\;s metal screws Wood screws

Installation parts are supplied for double hung windows up to 101.6 cm (40”) wide. Installation up to 137 cm (54’3 can be made with a special, wide window kit available from your dealer or service center.

listed in the chart. Follow the requirements for the type of plug on the power supply cord.

Wfrhg requirements

Electrical Shock Hazard

Disconnect power supply cord from receptacle before servicing.

Failure to follow these instructions could result in serious injury or death.

Note: Refer to model and serial label for BTUcapacity, amperage, voltage and refrigerant charge specifications.

power supply cord

models rated

kzt;rdmended grounding

For your personal safety, this appliance must be grounded. This appliance is equipped with a power supply cord having a 3-prong grounding plug. To minimize possible shock hazard, the cord must be plugged into a mating, 3-prong grounding-type wall receptacle, grounded in accordance with the Canadian Electrical Code, Part II or latest edition*, and all local codes and ordinances. If a mating wall receptacle is not available, it is the personal responsibility and obligation of the customer to have a properly grounded, 3-prong wall receptacle installed by a qualified electrician.

Panel A