TROUBLESHOOTING

Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.

Your refrigerator will not operate

Is the power supply cord unplugged? Plug into a grounded (earthed) outlet.

Has a household fuse blown or has a circuit breaker tripped? Replace the fuse or reset the circuit breaker.

Is the refrigerator or freezer control turned to the OFF position? Refer to the “Using the Controls” section.

Is the refrigerator defrosting? Recheck to see if the refrigerator is operating in 30 minutes. Your refrigerator will regularly run an automatic defrost cycle.

Is the refrigerator not cooling? For models with digital controls, turn the unit OFF then ON again to reset. See the “Using the Controls” section. If this does not correct the problem, call for service.

Are the controls not set correctly for the surrounding conditions? Refer to the “Using the Controls” section.

Are the doors not closed completely? Close the doors firmly. If they do not close completely, see “The doors will not close completely” later in this section.

Are the condenser coils dirty? This prevents air transfer and makes the motor work harder. Clean the condenser coils. Refer to the “Cleaning” section.

Are the door gaskets not sealed all the way around? Contact a technician or other qualified person.

NOTE: Your new refrigerator will run longer than your old one due to its high-efficiency motor.

The refrigerator seems to make too much noise

The sounds may be normal for your refrigerator. See the “Normal Sounds” section.

The lights do not work

Is the power supply cord unplugged? Plug into a grounded (earthed) outlet.

Is a light bulb loose in the socket or burned out? See the “Changing the Light Bulb(s)” section.

There is water in the defrost drain pan

Is the refrigerator defrosting? The water will evaporate. It is normal for water to drip into the defrost pan.

Is it more humid than normal? When it is humid, expect that the water in the defrost pan will take longer to evaporate.

The motor seems to run too much

Is the room temperature hotter than normal? The motor will run longer under warm conditions. At normal room temperatures, expect your motor to run about 40% to 80% of the time. Under warmer conditions, it will run even more.

Has a large amount of food just been added to the refrigerator? Adding a large amount of food warms the refrigerator. The motor normally will run longer to cool the refrigerator back down.

Are the doors opened often? The motor will run longer when this occurs. Conserve energy by getting all items out at one time, keeping food organized, and closing the door as soon as possible.

The ice maker is not producing ice or not enough ice

Has the ice maker just been installed? Wait 72 hours for full ice production to begin. Once your refrigerator is cooled, the ice maker should produce 70 to 120 cubes every 24 hours.

Is the freezer temperature cold enough to produce ice? Wait 24 hours after ice maker hook-up for ice production. See the “Using the Controls” section.

Is the ice maker wire shutoff arm in the OFF (arm up) position (on some models)? Lower the wire shutoff arm to the ON (arm down) position. See the “Ice Maker and Storage Bin” section.

Is the ice maker switch in the OFF (right) position (on some models)? Move ice maker switch to the ON (left) position. See the “Ice Maker and Storage Bin” section.

Is the water line shutoff valve to the refrigerator turned on? Turn on the water valve. See the “Water Supply Connection” section.

Does the ice maker mold have water in it or has no ice been produced? Make sure your refrigerator has been connected to a water supply and the supply shutoff valve is turned on. See the “Water Supply Connection” section.

Is an ice cube jammed in the ice maker ejector arm? For models with an interior ice bin, remove the ice from the ejector arm with a plastic utensil. For models with an ice bucket located on the freezer door, access the ice maker by depressing the ice sensor door on the upper left side of the freezer interior. While depressing the sensor door, lift the ice maker service door and remove the ice from the ejector with a plastic utensil. See the “Ice Maker and Storage Bin” section.

19

Page 19
Image 19
Whirlpool 2308045 manual Troubleshooting