Hot and cold water faucets:

Before you start...

Check location where washer will
,I I^ I,,,
De ~nstallea Proper lnstallatlon Is
your responsibility Make sure you
have everything necessary for
correct installation
Grounded electrical outlet
IS required. See Electrical
requirements.
Standpipe drain system: needs
a two-inch minimum diameter
standpipe with minimum carry-
Untape and open washer IId
Remove packages, hoses, and
1
must be withln 4 feet (122
literature rack from washer P A 1 centimeters) of the back of the
washer and provide water
pressure 5-100 PSI (34.5-689.6 KPa).
Laundry tub drain system:
needs a 20.gallon (75 liter) laundry
I 4!!3 II
tub. Top of tub must be at least
34 inches (86 centimeters) high
*
and no higher than 52 inches
(132 centimeters] from bottom of
washer. /

Tools needed for

InstaIIatfon. .I

Parts supplied

for installation.

away capacity of 17 gallons (64
liters) per minute. Top of star IdpIpe
must be at least 34
Inches (86 centimeters
high and no higher
than 52 inches
If a longer drain hose IS needed,
Part No. 388423 and the hose
extension kit, Part No. 285442, are
authorized parts dist
Water heater: set to deliver 140’ F
) water to the washer
Protection from weather: do not
store or operate washer below 32 F
(O’C). See Use and Care Q/de for
further information
Level floor: maximum slope under
- washer1 inch (25 millimeters).
Remove parts from packages. Check
that all Dads were included.
literature
package
4 drain hose
4 plastic strap
4 flat water
lter
hose washers J~C: washers
4 literature rack
xature rack
(not supplied
lied
with all models1 ielsl
4 hose clamp e 2 front leveling
1 grounding clamp legs with nuts
and screw 4 wire form

Electrical

requirements

Prefix “3” Models.
240 Volts, 5.0 Amps.
50 Hz., 8 Amp. fuse.
Electrical ground is required
on this appliance.
A fused electrical supply is required.
[Time-delay fuse or circuit breaker is
recommended.) It is recommended
that a separate circuit serving only
this appliance be provided.
WARNING: AN EXTENSION CORD
SHOULD NOT BE USED WITH THIS
APPLIANCE. SUCH USE MAY RESULT IN
A FIRE, ELECTRICAL SHOCK, OR OTHER
PERSONAL INJURY.

Recommended

grounding method

Do Not, under any circumstances,
remove the power supply cord
grounding prong.
For your personal safety, this appliance
must be grounded. This appliance is
equipped with a power supply cord
having a grounding plug.
To minimize possible shock hazard, the
cord must be plugged into a mating
grounding type wall receptacle,
grounded in accordance with local
codes and ordinances. If a mating wall
receptacle is not available, it is
the personal responsibility and
obligation of the customer to have a
properly grounded wall receptacle
installed by a qualified electrician. See
Figures l-3 to determine the proper
mating wall receptacle for the power
supply cord plug equipped with this
washer.
L...mJ-
240 Volt
grounding type
wau receptacle
Figure 4
Schuko
grounding type
Pow~o;;PPIY
I’ll
Figure 2
ALTERNATE SlYLE
grounding type
wall recsplacle
grounding plug

II

Figure 3
PANEL A