Whirlpool 3347017 Move washer to its permanent location, Actual size, Check Electrical, Panelc

12 Carefully tilt washer

n backward until front of washer is 3-4 inches off of floor. Insert 1or 2 corner posts.

actual size

13 Use legs and n nuts from parts

package. Screw nut down to within 1/2”of base.

into correct holes at each

front corner of washer until nuts touch washer. Do not tighten nuts until step 17.

15.

Tilt washer backward and remove corner post(s). Gently lower washer to floor.

Move washer to its permanent location.

Tilt washer forward raising back legs 1” (25mm) off of floor to adjust rear self-leveling legs. Gently lower washer to floor, Check levelness at the washer front and from front to back on each side using a carpenter’s level.

If washer is not level, screw the front legs up or down to adjust. Make final check with level.

When washer is level, use wrench to turn nuts on front legs up tightly against washer base. If nuts are not tight against washer base, the washer may vibrate.

18 Put “hook” end of drain H hose in tub or standpipe.

Secure drain hose by wrapping‘the plastic strap around the hose as shown in Figures A-C. If drain hose cannot be strapped in place, it must be cut exactly to length so the “hook” end is held tightly over the edge of tub or standpipe as shown in Figure D.

Note: If washer is moved to adjust drain hose. the washer must be leveled again. Repeat steps 1547.

Hose must be cut exactty to length so%ook”endls hetd tl@tlv over edge of tub or standptpe.

CHECK THATHOSEIS NOT TWISTEDOR KINKEDAND IS SECURELYIN PLACE.

19 CHECK ELECTRICAL

n REQUIREMENTSBE.SURE Y&l HAVECORRECTELECTRICAL SUPPLYAND RECOMMENDED GROUNDING METHOD.

4._-

20 Check that all parts are n now installed. See parts

list, Panel A. If there is an extra part, go back through steps to see which step was skipped.

21 Turn on water faucets W and check for leaks.

Tighten couplings if there is leaking.

Untape electrical

22 cord and plug into n grounded outlet.

you started with and that the

24 Take a few minutes and H read the Use and Care

Guide to fully understand your new washer. Now start the washer and allow it to complete the regular cycle.

Put the literature in the Literature Rack. (Literature Rack not supplied with

all models.]

Use caution when moving this appliance to prevent damage to floor coverings. Before moving, slide washer onto cardboard

or hardboard to prevent damage.

	You have
	successfully installed
	your new Whirlpool washer.
I	To get the most efficient use
	from your washer, read your
	Whirlpool Use and Care Guide.	\
I	Congratulations!	i

PANELC