5
WASHER USE

Understanding Washer Cycles

When the Cycle Control knob is set to a number and pulled out,
the washer fills (to the selected load size/water level) before
agitation and timing start. The washer begins agitating
immediately after filling; agitation occurs with the washer lid up or
down.
After agitation starts, the Cycle Control knob turns clock wise until
it points to an OFF area and the cycle ends.
NOTE: The washer pauses briefly throughout each cycle. These
pauses are normal for washer operation.

Loading

Loading suggestions

For these suggested full-sized loads, set the WATER LEVEL
selector to the highest setting.

Normal Washer Sounds

Your new washer may make sounds your old one didn’t. Because
the sounds might be unfamiliar, you may be concerned about
them. These sounds are normal.

During washing

When you select a small load size setting, your washer has a
lower water level. This can cause a clickin g sound from the upper
part of the agitator.

During drain

If water is drained quickly from your washer (depending on your
installation), you may hear air being pulled through the pump
during the end of draining.

After drain and before spin

When the cycle changes from draining to spinning, you may hear
gears engaging.

WASH RINSE

1. Fill 1. Fill
2. Wash
selected
time
2. Rinse
3. Drain†
No agitation 3. Drain
No agitation
4. Spin 4. Spin-Spray
rinse
5. Spin
†The Permanent Press cycle
partially drains, fills, agitates
briefly, and drains.
6. Off
EXTRA LARGE CAPACITY WASHERS
Heavy Work Clothes
2 pair pants
3 shirts
3 pair jeans
1 coverall
Delicates
3 camisoles
4 slips
4 panties
2 bras
2 nighties
Towel s
8 bath towels
8 hand towels 10 wash cloths
1 bath mat
Mixed Load
2 double sheets or
1 king size sheet(s)
4 pillowcases
6 T-shirts
6 pair shorts
2 shirts
2 blouses
6 handkerchiefs