INSTALLATION INSTRUCTIONS
BeforeYouStart
5.Check that the two (2) cotter pins were removed with the shipping strap.
WARNING
Excessive Weight Hazard
Use two or more people to move and install washer. Failure to do so can result in back or other injury.
NOTE: To prevent floor damage, set the washer onto cardboard before moving across floor.
RemoveShippingStrap
Removing the shipping strap is necessary for proper operation. If the shipping strap is not removed, the washer will make excessive noise.
1.Move the washer to within approximately 3 ft (90 cm) of the final location.
2.The washer must be in the upright position and not tilted before removing the shipping strap.
3.Locate the yellow shipping strap on the rear of the machine near the bottom.
ConnectDrainHose
Proper connection of the drain hose protects your floors from damage due to water leakage. Read and follow these instructions.
The drain hose is connected to your washer and is stored inside the washer cabinet.
Remove drain hose from washer cabinet
Gently pull the corrugated drain hose out of the washer from the top of the hose. Continue to pull the hose until the end emerges. Do not force excess drain hose back into the rear of the washer.
A 
A. Yellow shipping strap
4.Pull yellow shipping strap firmly, until both ends are completely removed from washer.
5
