Troubleshooting
Before calling for assistance please check the chart below for problems you can fix. It could save you the cost of a service call.
Dishwasher
PROBLEM
Dishwasher does not run or stops during a cycle
Dishwasher will not fill
Water remains in dishwasher
problems
CHECK THE FOLLOWING
Is the door tightly closed and securely latched?
Has the cycle been set correctly? See pages 5 and
Has a household fuse or circuit breaker blown or tripped?
If the motor stopped because of an overload, it will automatically reset itself within a few minutes. If it does not start, call for service.
Is the water supply turned on?
Is the dishwasher wired into a live circuit with the proper voltage?
Is overfill protector stuck in “up”position? Overfill protector should move up and down freely. Press down to release. See page 19.
Allow cycle to finish. A small amount of water remaining is normal.
Check the drain air gap (if installed). If it is clogged, follow the manufacturer’s cleaning instructions.
Detergent remains in covered section of dispenser
Has the cycle completed?
Is the detergent fresh and dry without lumps? See page 10.
Is the bottom rack in backwards? The rack bumpers must face the dishwasher door.
Dishes not as dry as you expected
White residue appears on front of access panel
Is the rinse agent dispenser empty? Using a rinse agent greatly improves drying. See page 11.
Do not use AIR DRY option on the next load. See page 13.
Is too much detergent being used? See page 10 for recommended amounts of detergent.
Some liquid detergents develop excess foam and residue on panel. Try a different brand to reduce foaming and eliminate buildup.
Dishwasher will | Is the bottom rack in backwards? The rack bumpers must face the |
not close | dishwasher door. |
24