Whirlpool 4370070 Decorator Door Panel Installation Instructions, Ul u, mm Panel Dimensions

Important

Do not discard dispenser trim or instructions.

Decorator Door Panel Installation Instructions

l/4” (6 mm) Panel Dimensions

Listed-below are required height x width dimensions for decorator panels. Panels are not supplied with this kit and can be purchased locally. Refrigerator panels should not

weigh more than 30			pounds and freezer panels should not
weigh	more than, 15 pov&			L	ICI-IL
	WI It-r t(			b,iVldZn4
Refrigerator-Door		Panel		63 3/32”	x 19 310”
Upper	Freezer	Door	Panel	i a 3tw	x i 3 3149’
Lower	Freezer	Door	Panel	31 9/l 6” x 13 3/4”

2.Dispenser Models

Remove crushed/cubed ice switch cover on dispenser by placing taped edge of putty knife underneath cover and pulling out. Release bottom clips on dispenser cover by placing taped edge of putty knife underneath cover and pulling out. Release top clips by holding bottom of dispenser cover out and sliding up.

General
ul(u	A WARNING
	Electrical	Shock Hazard
Disconnect electrical power before installing panels.
Failure to do so can result in death or electrical shock.
	Personal	Injury Hazard	L
Wear gloves and protect arms when handling trim			3. Remove door handle inserts by placing screwdriver at
			top of door handles in area between handle and insert
pieces.
			and pulling forward. Pull edge of inserts forward along
Failure to do so could result in cuts or other serious
			length	of handles.
injury.
			’I II	-

Caution

To avoid property damage, protect soft vinyl or other flooring with cardboard, rugs, or other protective material.

Procedure

Important

Save all screws and reuse in original location.

1. Remove top handle end caps by removing screws.

A WARNING

Failure to do so could result in personal injury.

4. Remove door handles by removing screws.

Important

Decorator panels should be cut to “l/4” panel dimensions.

Refer to “l/4” Decorator Panel Dimensions” section.