Before you start...
Check location where water pump will be installed. Proper installation is your responsibility. Make sure you have everything necessary for correct installation,
The serial/rating information is located on the base of pump.
Important: Observe all governing codes and ordinances.
Earthed electrical outlet is required. See Electrical requirements,
Water connections to pump Do Not require sealing compounds to prevent leaking.
water bottle | water bottle |
tubing% |
I
switch
Electrical requirements
Electrical
. Electrical earth is required on this appliance.
. If cold water pipe is interrupted by plastic,
. Do Not earth to a gas pipe.
l Do Not modify the power supply cord plug. If it does not fit the outlet, have a proper outlet installed by a qualified electrician.
l Do Not have a fuse in the neutral or earthing circuit. A fuse in the neutral or earthing circuit could result in electrical shock.
l Do Not use an extension cord with this appliance.
If codes permit and a separate earthing
wire is used, it is recommended that a qualified electrician determine that the earthing path is adequate.
Panel A
Personal Injury Hazard
l Do Not use water pump to pump any other liquids. Use only for bottled water.
. Clean system after extended periods of
Failure to follow these instructions may result in personal injury.
to rffrigerator
“$
“,P a
t.
Shock Hazard
l Check with a qualified electrician if you are in doubt as to whether the appliance is properly earthed.
l This appliance is equipped with a power supply cord having a
earthed in conformance with National Electrical Codes, and all local codes and ordinances. See Figures 1 and 2. If a mating wall receptacle is not available, it is the personal responsibility and obligation of the customer to have a properly earthed
Failure to follow these instructions could result in a serious injury or death.
A fused electrical supply is required.
recommended.) It is recommended
that a separate circuit serving only this appliance by provided.
Electrical Shock Hazard It is the customer’s responsibility:
l To contact a qualified electrical installer.
l To assure that the electrical installation is adequate and in
conformance with National Electrical Codes, and all local codes and ordinances.
Failure to do so could result in fire, electrical shock or other personal injury.
Property/Product Damage
l Do Not store water bottle and water pump in an area where temperatures fall below O°C(320F).
Failure to follow these instructions may result in property or product damage.
Tools needed for installation:
knife or | 6 |
| |
tubing |
|
cutter |
|
a.
Parts sup lied for hstal Patgon:
bottle | cap |
4. | this end is |
“83 |
l/4” outside | 3/S” outside |
diameter | |
tubing | diameter |
| tubing |
Parts not supplied for installatiron:
l fittings | to | connect | l If additional | tubing | is | |
l/4” 0. | D. tubing to | required, | you will | need | ||
refrigerator | inlet | tubing | connector, | |||
|
|
| 4319153 | and | l/4” | O.D. |
|
|
| tubing, | Part | No. 4319151. | |
Schuko |
|
|
| |||
wall | receptacle | t% |
|
|
| |
|
|
| ““a, |
|
|
|
Schuko earthing
plug
Ngliqdg
*’ ” Power supply cord
uu
Figure 1
\
supply cord
Figure 2