3.If connectinq to a
A.Remove termrnal block cover.
B.Remove the ground strap from the termrnal block and from the appliance frame. Retain the ground screw.
C.Connect the grounding wire (green) of the copper- power supply cord to the frame of the appliance with the grounding screw, using the hole in the frame where the grounding strap was removed. See Figure5
D.Connect the neutral (white) wire of the copper
Power supply cord to the center
E.Replace the terminal block cover.
ILVER-COLORED
BARE OR NO
GROUNDING
(WHITE OR CENTER)
STRAIN RELIEF
WIRING DEVICE
(40 AMPERES)FOR COPPER POWER SUPPLY
1 CORD.
FIGURE 5
STEP 4 LEVEL AND POSITION RANGE
1.Move the range to its final operating position and check the level of the range by using a small spirit level on the oven rack. See Figure 6. The range can be leveled from side to side and front to rear by adjusting the four leveling legs.
FIGURE 6
2. Make the electrical connection:
A. Plug the flexible copper connector (pigtail) into an approved, receptacle (where local codes permit the use of a pigtail),
OR
B. Connect the flexible armored or
3.Remove the tape holding the oven light switch actuator. See Figure 7.
NOTE: As shipped from the factory, the oven lrght switch actuator is held depressed by tape. To prevent switch damage, the swatch actuator should be taped whenever the range is transported.
FIGURE 7
4