Whirlpool 56OSOLSPC5 816412 manual Operation, Before You Call For Service, Check

CHECK

OPERATION

Refer. to

the

operation

instruction

card

packaged

with the

Models

(40”)

with

Left Hand

Auxiliary

Oven

range to

check

for

proper care and

cleaning

of your

range.

1.

Check

Large

Oven

elements as previously

described.

CAUTION:

Do not

touch

the elements.

They

may

be

hot

and you

may

get burned.

2.

Turn

Left

Oven

thermostat

to 400’

F. The bottom

element

should

heat.

SURFACE ELEMENtS

1.Turn on each of the four (4) surface elements and check to see that they heat. On models so equipped, check the surface element indrcator light(s).

3.Turn Left Oven thermostat to BROIL. The top element should heat.

OVEN ELEMENTS

CAUTION: Do not touch the elements. They may be hot and you may get burned.

Models with Two Position Selector Switch

1. Turn Selector Switch and thermostat to BROIL. Observe the oven elements, the upper element only should heat.

2.Turn the Selector Switch to BAKE and thermostat to

400’ F. Observe the oven elements, the lower element only __ should heat.

Models with Pre-Heat

1.Turn the Selector Swatch to PRE-HEAT and thermostat to 400” F and observe the oven elements. Both elements should heat.

2.Turn thermostat to BROIL and Selector Switch to

HI-BROIL, and observe the oven elements. Upper element only should heat

NOTE: On standard and contrnuous-cleaning models, be

sure timer is set for Manual operation. On self-cleaning models, set the Bake/Clean switch to BAKE.

Eye Level Models

1.Set the trmed Oven Selector Switch to MANUAL.

2.Check the Lower oven by following Steps 1 and 2 for Models with Pre-Heat.

3.Check the Upper oven by turning the upper oven

thermostat to HI.BROIL. The upper element should heat.

4.Reset the Upper oven thermostat to OFF, and turn back to 400” F. Both elements should be on at first. After the

thermostat cycles, the bottom element only will cycle “On” and “Off” to marntain the selected oven temperature.

CLOCK (If so equipped)

Refer to the operation instructions packaged In the range

oven, for operation of the clock.

BEFORE YOU CALL FOR SERVICE...

1. Make sure range copper power cord (prgtail) is plugged

ill.

2.Check to make sut.e the house fuse 01. crrcuit breaker for your range is not blown or open.

NOTE: The serial plate for 30” ranges is located on the upper left corner of the oven front frame. On 40” models the serial plate is on the front frame of the small left

compartment or oven

In lhe event your WHIRLPOOL appliance should need service. call Ihe dealer from whom you purchas

ed Ihe appliance or a WHIRLPOOL lranchlsed TECH-CARE’ service company He IS ,n Ihe Yellow

Pages 01 your r&phone dtreclory Med under “Appliances-HousehoId-Malor-Service and Repair You

can also oblaln his name and number by dialing. free, Ihe Whfrlpoo COOL-LINE’ Serwce (800) 2531301 Dtal /USI as you normally dial long distance A special operaror WIII tell you Ihe name and number of your wares, Whirlpool TECH~CARE serv,ce a,,,.?, Dur,ng norma, work,ng hours. Wh,rlpool consu,,an,s al lhts same number will also answer any ques!lons about opera-tng or ma~nla~mng your appliance nor covered ,n your “se and Care Guide

WHIRLPOOL CORPORATION, BENTON HARBOR, MICHIGAN 49022

5