To Remove:
1.Push in the edge of coil element toward the receptacle. Then lift it enough to clear the burner bowl.
2.Pull the coil element straight away from the receptacle.
3.Lift out the burner bowl.
To Replace:
1.Line up openings in the burner bowl with the coil element receptacle.
2.Holding the coil element as level as possible, slowly push the coil element terminal into the receptacle.
3.When the terminal is pushed into the receptacle as far as it will go, push down the edge of the coil element opposite the receptacle.
ELECTRONIC OVEN CONTROL
ABC D
K | J | I | H | G | F | E | |
A. Bake |
|
| E. Cancel |
|
| I. Clean (on some models) | |
B. Clock/timer display |
|
| F. Keep warm |
|
| J. Cook & hold | |
C. More (+)/less |
| G. Clock |
|
| K. Broil | ||
D. Timer |
| H. Delay |
|
|
| ||
|
|
|
|
|
|
|
|
Display |
|
|
|
|
|
| Clock |
When power is supplied to the range or after a power interruption, the last clock time before power was interrupted will flash.
Bake or Lock may flash rapidly in the display to alert you if there is an error or problem. Press CANCEL and reset clock if needed.
When the oven is in use, the display shows the temperature and oven setting.
When the oven is not in use, the display shows the time of day.
When using the TIMER, for settings of 1 to 59 minutes, the display will count down in minutes. The last minute will count down in seconds. For settings of 1 hour or more, the display will count down hours and minutes.
Cancel
The CANCEL button stops any function except the Clock, Timer and Control Lock. When you press the CANCEL button, the display will show the time of day, or the time remaining if the TIMER is being used.
The clock can be set to display time in a
To recall the time of day when another time function is showing, press the Clock pad.
Clock time cannot be changed when the oven has been programmed for Delay Cook, Clean, or Cook & Hold.
To Change the Clock to 24-hour Format:
1.Press and hold CANCEL and DELAY for 3 seconds.
2.Press the “up” or “down”’ arrow pad to select 24 hour.
To Set:
1.Press CLOCK. The colon will flash in the display.
2.Press the “up” or “down”’ arrow pads to set the time of day.
3.Press CLOCK or wait 4 seconds. The colon stops flashing.
To Cancel the Clock Display:
If you do not want the time of day to display:
Press and hold CANCEL and CLOCK for 3 seconds. the time of day will disappear from the display.
7
