CHECKING YOUR VENT

VENTING (CONT.)

3.You can exhaust from the rear, left, right, or bottom of the dryer.

Exhaust from the rear of the dryer: The exhaust vent can be routed up, down, left,

right, or straight out the back of the dryer. Space requirements are listed in your Installation Instructions.

4.Use the straightest path possible when routing the exhaust vent. Use

the fewest number of elbows and turns. Allow room when using elbows or making turns. Bend vent gradually to avoid kinking.

wWARNING

Fire Hazard

Cover unused exhaust holes with one of the following kits: #279818 (white), #279819 (almond), #279820 (ebony).

Contact your local dealer.

Failure to do so can result in death, fire, electrical shock, or serious injury.

Exhaust from left, right, or bottom of dryer: To convert the dryer for exhaust out the right or left side, or through the bottom, you must use one of the following kits:

Exhaust Kit No. 279818 (white)

Exhaust Kit No. 279819 (almond)

Exhaust Kit No. 279820 (ebony)

An exhaust kit can be ordered by calling

1-800-442-9991and following the instructions and telephone prompts you hear.

5.Use duct tape to seal all joints. Do not use screws to secure vent. Lint may catch on screws.

6.Clean exhaust vent periodically, depending on use, but at least every 2 years, or when installing your dryer in a new location.

Disconnect vent from the dryer and clean one section at a time until you reach the exhaust hood.

Use the hose attach- ment on your vacuum, or a pole or wire with a

feather duster or rag attached, to clean out lint.

Be sure the flapper on the outside end of vent moves freely.

When cleaning is complete, be sure to follow the Installation Instructions supplied with your dryer for final product check.

7

Page 7
Image 7
Whirlpool 8280525 warranty Checking Your Vent