Whirlpool 8500 warranty Adding a dish during a cycle, Changing a cycle setting, Changing an option

Adding a dish during a cycle

You can add an additional item to the dishwasher reaches LIGHT WASH. See page 8.

1.Lift up on the door latch to unlatch the door and stop the cyde. Wait a moment for the spray action to stop before open- ing the door.

2.Open the door and add the dish.

3.Close the door. Do not latch it. Wait

anytime before the Cycle Control knob

30 seconds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cyde.

4.Press door in to latch it. The dishwasher will start where it stopped.

Changing a cycle setting

You can change a setting anytime during any cycle.

1.Lii up on the door latch to unlatch the door and stop the cycle.

2.Turn the Cycle Control knob dockwise to the cycle you want.

3.Push the desired Cycle Selection button.

4.Check the detergent dispenser to be sure it is properly filled for the new cycle. See page 10.

NOTE: Turning the Cycle Control knob may cause the covered section of the detergent dispenser to open. Be sure to fill the covered section if the cycle uses detergent in both sections.

Close and latch the door. The dishwasher will automatically start the new cycle.

Changing an option

You can change an option anytime during a cycle. To change the selected option(s):

1.Push the RESET OPTIONS button.

2.Push an Option Selector button for each desired option.

Canceling a cycle

You can cancel a cycle anytime during the cycle.

1.Turn the Cycle Control knob slowly clockwise to the drain portion of the wash or rinse. You will hear water draining when you have advanced to the proper location.

2.Let the dishwasher drain completely.

3.Lii up on the door latch to unlatch the door.

4.Turn the Cycle Control knob clockwise to point to OFF.