Whirlpool 8EDZOZK manual Removing the freezer bin, Using the ice cube trays, Edzozk

Removing the freezer bin

For proper air movement, keep the freezer bin in place when the refrigerator is operating.

To remove the bin:

1.Slide bin out to the stop.

2.Lii bin at the front to clear the stop.

3.Slide bin out the rest of the way.

To replace the bin:

1.Place bin on the slides.

2.Make sure the stops clear the front of the slides.

3.Slide bin in.

Using the ice cube trays

If cubes are not used, they may shrink. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get.

To remove ice:

1.Hold tray at both ends.

2.Twist slightly.

Using the automatic ice maker

(Factory-installed on ED22ZR, optional on EDZOPK

If you have the automatic ice maker accessory
(Part No. ECKMF-90). or if you plan to add one
later, there are a few things you will want to
know:
l The ON/OFF lever is a wire signal arm.
	Down . . . to make ice automatically.
	up . . . to shut off the ice maker.
	NOTE: Do notturn ice m-on									Raise
	!xnnected	to the		water	sup&.		lnstructrons		for
	Jce maker	water		sup&m				m		signal
										arm	to
	ed to the back of the refrlaerator
										Stop	ice
	cabinet
										maker.
l The dial or lever on the side of the ice maker
	changes the size of the cubes.									Lower
	Shake the	bin	occasionally			to keep		cubes
l										signal
	separated	and	to	obtain	increased			storage		arm	to
	capacity.									stat-t	ice
l	It is normal	for	ice crescents			to	be	attached	by	maker.

a corner. They will break apart easily.

l You will hear water running when ice maker is working. You’ll hear ice fall into the bin. Don’t let these sounds bother you.

and EDZOZK)

@%aL ,) On

11