Whirlpool 915 Adding an item during, Using delay wash, Cycle, Clean signal light, On some models

Adding an item during

You can add an additional item to the dishwasher anytime before the cycle control knob reaches Light. Items added after the cycle control knob reaches Light may only be rinsed.

1.Lift up the door latch to stop the cycle. Wait for spraying action to stop before opening the door.

2.Open the door and add the item.

Using delay wash

(on some models)

You can set the dishwasher to start a cycle from 1 to 4 hours later.

1.Press the desired Cycle pad.

2.Press the desired Option pad(s).

3.Turn the cycle control knob clockwise to the number of hours (from 1 to 4 hours) you want the dishwasher to delay before the selected cycle starts.

4.Close and latch the door. The Delay/ Water Heating signal light will come on until the selected cycle starts.

NOTE:

l You can add items while time is counting down. Close and latch the door. The cycle control knob will not advance if the door is unlatched.

l Rinse-Wash Later and Light cycles cannot be delayed.

l The DelayWater Heating signal light will also come on while the water is heating during all cycles.

acycle

3.Close the door, but do not latch it. Wait 30 seconds for the air in the dishwasher to warm up. Doing so reduces the amount of moisture in the vent when restarting a cycle.

4.Close the door firmly until it latches. The dishwasher resumes the cycle.

The clean signal light

(on some models)

The Clean signal light will come on when a washing cycle is complete. To turn it off, turn the cycle control knob clockwise slightly until the light goes off.