For Heating
NOTE: This product Is not deolgned to be used as a primary heat source. It Is intended for supplemental heating only.
LO HEAT
for reduced air movement with heat.
HI HEAT
for maximum air movement with heat.
Turn THERMOSTATCONTROL to the mid (number 6) setting. You can adjust the air con- ditioner’s heating performance by resetting the thermostat control to a lower number for more heat. Turn to a higher number for less heat.
Model ACH082 ONLY
Use of the heat settings on this model activates a reverse cycle operation that works as a heat pump. It changes the operating mode of the refrigeration system to provide supplemental heat for chilly days and evenings. When raising the thermostat in this heating mode, the compressor (motor) may shut off. When the compressor is turned off with either the fan speed control or the thermostat control, wait
Using the Exhaust Control
This control setting can be used to draw stale or smoky air from the room or to circulate air in the room, without cooling or heating. NOTE: Make sure the exhaust vent control Is returned to the CLOSED sefflng when cooling, heating or room alr circulation is desired. Energy etflclency is decreased when operating In EXHAUST and cooling or heating at the same time.
1.To exhaust room air:
l Set EXHAUSTVENTcontrol to OPEN.
l If cooling is desired, set FANSPEED CONTROL to desired COOL setting.
l If heating is desired, set FANSPEED CONTROL to desired HEATsetting.
l If cooling or heating is not required, set FANSPEEDCONTROL to FAN ONLY.
2.To circulate room air:
l
l
l
l
Set EXHAUSTVENTcontrol to CLOSED.
If cooling is desired, set FANSPEED CONTROL to desired COOL setting.
If heating is desired, set FANSPEED CONTROL to desired HEATsetting.
If cooling or heating is not required, set FANSPEEDCONTROL to FAN ONLY.