Whirlpool ACE2400, ACE3411, ACE3211, ACE3200, AEE2000 HowtoUseYourRange, HOW to Adjust the Flames

2

Check with soap solution for leaks.

If the installation is not new, you should clean it in order to avoid the obstruction of orifices and/or pilots.

To make it easier to move the appliance, the installer should loop the 3/8" copper tubing as shown in the illustration.

GAS L.P. OPERATING PRESSURE 11 inches Water Column

NATURAL GAS OPERATING PRESSURE 7 inches Water Column

I M P O R T A N T

•This range is adjusted at the factory for use with L.P. gas.

•To use this range with natural gas, you must replace the surface and oven burner orifices, call Servicio Acros-Whirlpool, the phone number is shown in the last page. The technician must make sure that the connections have no leaks and the gas pressure in the range is the same as shown in the charts.

NOTE: To operate this range with natural gas, is
required a kit according to the chart:
Range Model	Kit Number
Model ACE2200	98014527
Model ACE2400	98014527
Model ACE3200	98014562
Model ACE3211	98014528
Model ACE3411	98014528
Model AEE2000	98014527
This kit is available at your nearest Authorized
Service Center.

HowtoUseYourRange

HOW TO ADJUST THE FLAMES

NOTE: Do not obstruct the gas exhaust of the oven or broiler

If the range has yellow flames, it may require adjustment to the air shutters:

• How to adjust the air for surface burners:

1	Remove the	2	Unscrew the	screws	3
	knobs.		of front and below the
			manifold panel and
			remove it.
NOTE: Because of different altitudes above sea level and variations
in the supply of gas, you may need to adjust the main air intake
to the burners. This will result in a better air-gas mixture and thus
a better operation.

Adjust the air shutters individually. Light the burner, then push or pull the air shutter until you get a blue flame. Replace the manifold panel, screws and knobs.

4