Using the EXHAUST CONTROL
The EXHAUST CONTROL draws stale or smoky air from the room or circulates existing room air.
To exhaust room air:
1.Set EXHAUST CONTROL to OPEN.
2.Set FAN CONTROL to desired setting.
3.Set THERMOSTAT Control to desired setting.
To circulate room air:
1.Set EXHAUST CONTROL to CLOSED.
2.Set FAN CONTROL to desired setting. If no cooling is desired, set FAN CONTROL to HIGH FAN or LOW FAN.
3.Set THERMOSTAT Control to desired setting.
NOTE: For maximum performance, the EXHAUST CONTROL must be in the CLOSED position when cooling or room air circulation is desired.
EXHAUST CONTROL
CLOSEDOPEN
FAN CONTROL
Cooling at low outside
When the outside temperature drops below 70°F and the air conditioner is cooling, frost may form on the coils behind the front panel. This will block the airflow into the room.
To defrost the coils:
l Set the FAN CONTROL to the OFF setting and allow the ice to melt, then resume normal operation.
temperatures
To prevent frost
1.Set the FAN CONTROL to the desired
COOL setting. | FAN CONTROL |
2.Set THERMOSTAT Control to the middle setting.
3.Make sure all louvers are open.
Do not try to operate your
air conditioner on SUPER COOL, NORMAL COOL or LOW COOL when outside thermostat is below 65°F. The inside evaporator coil will freeze up and the air conditioner will not operate properly.
Changing air direction
The louvers in the top grille area of the air conditioner control the direction of the cooled air.
For left or right airflow:
l Move the louvers in the direction you want the air to go.
For upward airflow: | left/right airflow |
|
l Pull the tabs at the bottom of the louvers to tilt louvers outward.
