Whirlpool ADG 175 manual Dishwasher installation steps, 【 】

●Dishwasher installation steps

1Install the furniture door to the outer door of the dishwasher using the brackets provided. Refer to the template for positioning of the brackets.

2Adjust the tension of the door springs by using an Allen key turning in a clockwise motion to tighten the left and right door springs. Failure to do this could cause damage to your dishwasher (Illustration 2).

3Connect the inlet hose to the cold water supply .

4Connect the drain hose. Refer to diagram.(Figure 6)

5Connect the power cord.

6Affix the condensation strip under the work surface of cabinet. Please ensure the condensation strip is flush with edge of work surface.

7Place the dishwasher into position.

8Level the dishwasher. The rear feet can be adjusted from the front of the dishwasher by turning the screws on the left and right hand side of the cabinet (Illustration 5A). To adjust the front feet, use a wrench and turn the front feet until the dishwasher is level (Illustration 5B).

9The dishwasher must be secured in place. There are two ways to do this:

A. Normal work surface-secure to the work surface by using two woodscrews ensuring the dishwasher weight is not being hit by the surface (Illustration 6).

B. Marble or granite work top-secure the bracket to the side panel of the dishwasher and secure the dishwasher to the furniture housing. Put the rubber cap over the screw (Illustration 7).

	2
	6
	4
SCREW
CONE GEAR
5A	5B
	5
	RUBBERCOVER
	7
	SCREW
	【Figure 7】

20