Whirlpool ADG 175 manual Water Connection, Extension Hose, Syphon Connection, Start of Dishwasher

WARNING!	Improper connection of the equipment earthing conductor can result in the risk of an electric shock.
		for personal safety:
	Check	with a qualified electrician or service representative if you are in doubt whether the
		DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.

appliance is properly earthed.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE EARTHING

Do not modify the plug provided with the appliance. If the plug does not fit properly to the outlet,

CONNECTION FROM THE POWER CORD. please have a qualified electrician to install a proper outlet.

Water Connection

	Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
	that it is fastened tightly in place.
	If the water pipes are new or have not been used for an extended period of time, let the
	water run to make sure that the water is clear. This precaution is needed to avoid the
	risk of the water inlet to be blocked and damage the appliance.
	The water supply to the appliance can also be connected to the household hot water
	line (such as, central system, heating system),as long as it does not exceed a
	temperature of 60 C. In this case, the wash cycle time will be shortened by about 15
	minutes and the wash efficiency slightly reduced.
	The connection must be made to the hot water line following the same procedures as
	described in the section for the connection to the cold water line.
WARNING!	In order to avoid that there is more water staying in the inlet hose, please close
	the hydrant after using.(Not applicable to appliances without aqua-stop.)

Extension Hose

If you need a drain hose extension, make sure to use a similar drain hose.

It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.

Syphon Connection

The waste connection must be at a height of between 50 cm (minimum) and 100 cm (maximum) from the bottom of the dish. The water drain hose should be fixed by a hose clip.

Start of Dishwasher

The following things should be checked before starting the dishwasher.

1The dishwasher is level and fixed properly

2The inlet valve is open

3There is a leakage at the connections of the conducts

4The wires are tightly connected

5The power is switched on

6The inlet and drain hoses are knotted

7All packing materials and printings should be taken out from the dishwasher

After installation, please make sure to keep this manual.

The content of this manual is very helpful to the users.

22