Whirlpool Air Conditioner manual Chart-C, Receptacle Wiring

RECEPTACLE WIRING

RECEPTACLE WIRING should be at least as large as size shown on electrical Chart B. Use copper wire only. It is the personal responsibility and obligation of the customer to provide proper and adequate receptacle wiring installed by a

qualified electrician. OBSERVE NATIONAL

ELECTRICAL CODE AND ALL LOCAL

GOVERNING CODES AND ORDINANCES.

A separate electrical supply is required on a separately fused circuit. Do not fuse ground- neutral.

See Chart C for receptacle voltage require- ments, proper fuse size, wire and wiring con- nections which must conform with rating of

the appliance. Do not use an extension cord.

RECOMMENDED GROUNDING METHOD

For your personal safety, this appliance must be grounded. This appliance is equipped with a power supply cord having a 3-prong grounding plug. To minimize possible shock hazard, the cord must be plugged into a mating 3-prong grounding type wall receptacle, grounded in accordance with the National Electrical Code and local codes and ordinances. If a mating wall receptacle is not available, it is the personal responsibility and obligation of the customer to have a properly grounded 3-prong wall receptacle installed by a qualified electrician,

For 230 volt and 230/208 volt models with serial plate amperes up through 16.0

Refer to Chart C for specific wiring and recep-

tacle information to be used.

OBSERVE ALL LOCAL GOVERNING CODES AND ORDINANCES.

Do not, under any circumstances, remove the power supply cord ground plug.

ELECTRICAL GROUND IS REQUIRED ON THIS APPLIANCE.

A three-wire, single-phase 60 hertz AC only electrical supply is required.

Chart-C

		RECEPTACLE
PLUG	AND	VOLTAGE
RECEPTACLE		(60	HERTZ				SERIAL PLATE
DATA		AC	IN ALL				AhlPERES
		INSTANCES)
		MODEL		WITH
RECEPTACLE		SERIAL		PLATE
		OF 230		VOLTS
							up
							through
							16.0
		SERIAL		PLATE
FLAT BLADE	GROUND	OF	2301206
	PRONG	VOLTS
		(197.6		MIN
		253	MAX		)	I
USE TIME-DELAY
FUSE							TYPE
OR TIME		MINIMUM						I
DELAY	CIRCUIT	RECEPTAC			:LE	1	OF BRANCH
BREAKER		WIRE		SIZE			CIRCUIT	I
RATING IN								I

AMPS

RECEPTACLE WIRING

RECEPTACLE WIRING should be at least as large as size shown on electrical Chart C. Use copper wire only. It is the personal responsibility and obligation of the customer to provide proper and adequate receptacle wiring installed by a

qualified electrician. OBSERVE NATIONAL

ELECTRICAL CODE AND ALL LOCAL

GOVERNING CODES AND ORDINANCES.

5