Whirlpool Air Conditioner manual Type

11l Drill holes in the cabinet and attach it securely to finish frame. Use ten #lO x 1” wood screws (four screws for each side and two screws for the top; not included). Do not overtighten screws or cabinet will distort and provide a poor air seal between cabinet and unit.

12l Insert plastic drain-cup spout and metal holder (on certain models) into hole at rear of cabinet, as shown in Figure 8. Spout should be facing downward through hole. OPTIONAL: During high humidity, condensate may drip from the outside of your air conditioner onto the

ground below. If your air conditioner is installed where this is undesirable, you can direct the water to a more suitable spot by simply attaching a 5/8” inside-diameter, thin walled hose to the drain spout at rear of cabinet (see Figure 9). On models without plastic drain cup spout, use flashing as needed to guide water.

Note the type of drain parts you have. Insert

drain cup according to instructions in Figure 8.

Figure 8

			PLACE	PLASTIC 1
			DRAIN	INTO HOLE
			IN REAR OF
		CABINET WITH
			SPOUT DOWN
				I
				r---l
				L-Q,	1
INTO METAL		r-l		I
BRACKET AND		I’	’
INSERT	INTO
CABINET	RAIL
SLOTS		I
TYPE 1		1	TYPE 2
Figure 9	OUTSIDE		4
I				ROOM
				SIDE
			e

13l If you received one adhesive-backed seal strip

(l/4” x l/2”), remove paper backing from seal and install on air conditioner as shown in Figure 10.

Fig1

14l Insert air conditioner into cabinet. Do not push against sharp fins and plastic parts.

Attach green ground wire to the left-front corner of unit base by using retainer screw (see Figure 11).

Figure 11

SCREW I GROUND WIRE

Figure 12

BOTTOM WEATHER SEAL -PRESS UPWARD (Adhesive side on bottom of base )

15l For installation of bottom weather seal on unit with 18 3/4”-high cabinet, see Figure 12.

16. Attach front, by placing bottom edge on clips and pushing top down, then in and up.

17. Caulk all outside wall openings around cabinet.

18l If needed, install molding around room side of cabinet.

9