Whirlpool CGS365H Setting The Controls, Push And Turn, You See, Press, continued on next page

				USING THE SELF-CLEANING CYCLE
SETTING THE CONTROLS
	1. Set the oven control knob to CLEAN.	PUSH AND TURN		YOU SEE
	The door will lock itself within 6 seconds. If the		WARM	OVEN ON light goes
	door has a problem locking, it will try to lock	BROIL		on. DOOR LOCKED/
			200
	itself for 1 minute. If the door fails to lock, the			CLEANING light
		CLEAN	250
	Self-Cleaning cycle will cancel. An error code			flashes until you
			300
	will be displayed.			close door, then is
			350
	NOTE: Do not attempt to open the door while in	500	400	solid. HEATING light
		450
				goes on when oven
	the locking mode.
				starts heating.
	2. Set the cleaning time (optional).	PRESS
	Press the “up” (s) or “down” (t) pad(s) to
	select a clean time between 2 hours, 30
	minutes and 4 hours, 30 minutes.
	NOTE: The Self-Cleaning cycle will
	automatically set a 31⁄2 hour cycle unless a
	different time is selected.
	3. During the last 30 minutes of the Self-Cleaning			YOU SEE
	cycle the oven will start to cool down.			OVEN ON and DOOR
				LOCKED/CLEANING
				lights are on. HEATING
				light goes off and COOL
				appears in display.
	Once the oven goes below the locked			YOU SEE
	temperature:
				OVEN ON light flashes.
				DOOR LOCKED/
				CLEANING light goes
				out when door unlocks.

4. Turn the oven control knob to OFF.	TURN
	BROIL
	CLEAN

500

WARM

200

250

300

350

400

450

YOU SEE

OVEN ON light goes out and time of day appears in display.

5.After the oven is cool, wipe off any residue or ash with a damp cloth or sponge.

If needed, touch up spots with a mild abrasive cleanser or cleaning sponge.

continued on next page

19