Whirlpool DP3840XP manual Caused by

PROBLEM

Dishes not washing clean

Etching - permanent tllmlng which cannot be removed

Dishes 6 lnterlor of dlshwasher yellow or brown

CAUSED BY

Water Is not hot enough

Improper loadrng

Spray arm or arms not rotatrng freely

Not enough detergent or Improper

detergent

“0ld”detergent

Waterpressuremay

be low, dishwasher IS not frlltng properly

loo much detergent In soft water

Inadequate nnsrng

Iron or manganese tn water

SOLUTION

Water temperature should be at least 140°F (60°C). Set water heater thermostat to o higher setting Run water at sink until hot before startrng

Make sure dishes and glassware are loaded so spray

reaches all surfaces and Items drain properly Do not ov- erload Do not nest Items

Make sure large items do not block spray from reaching detergent dispensers

Check spray arms to make sure they turn freely after load- ing. Be sure a utensil has not prevented therrturnrng.

Use more dishwasher detergent Use detergent with hrgh-

est available phosphorus content especially with hard water

Use only fresh, dry dishwasher detergent Store tightly closed box in cool, dry place. Discard old, lumpy deter- gent. Do not fill dispensers until ready to start dishwasher

If water pressure is low, do not use water for other purposes while dishwasher IS running (to assure correct fills]

Check for rornbow hue on glasses A rainbow hue IS the first stgn of etching (corrosron of glass) Reduce the amount

of dishwasher detergent Use a detergent with a lower phosphorus content

If water pressure IS low do not use water for other purposes

while dishwasher IS running [to assure correct water fills). Make sure dishes and glassware are loaded properly to

assure adequate rinsing and draining. Do not overload

Temporary

remedy:

1

Set empty

dishwasher

for

a “one wash”

cycle

2

Start

dishwasher

and

unlatch

door

to

stop

it when it has

filled for the wash part of the cycle.

3

Add’.to’

2 cup

(120

to

240

ml)

of

citric

acid

crystals

[usually

available

In

drugstores]

4

Close

and latch

door

to complete

cycle

Permanent

solution:

Install

an

iron or

manganese

falter to

home water

supply

-,.

Small	dark			Allowrng		salty	or
spots	on			acidic	foods		such	OS
flatware	-			mayonnaise,			vinegar,
stalnless		steel,		fruit juices,		salad
sliver	plate,		or	dressings,		milk
sterling	or		rust	products		to remain		on
spots	on			flatware
stalnless		steel		Undissolved
				detergent		coming		in
				contact	with		flatware
				.
BronzetarnIsh				Srlverplote		is worn		off.
on sllverplate				Exposed		base	metal
				to kes on a bronzed
				hue.
Water	lett		In	Dishwasher		cycle		not
bottom	of			completed
dlshwasher				Clogged		drain air

gap

Rinse flatware that IS to stand for several hours before washing (use Rinse & Hold) Clean stained items with silver polish and re-wash Do not put stalnless steel and sliver

tlatware In the same sllverware basket compartment. Direct contact between these metals can cause perma- nent damage to the sliver.

Remove spots with silver polish Avord spilling dry deter- gent on wet flatware

Remove tarnish with srlver polish Hove silver replated

Allow dishwasher to complete cycle.

Some plumbing codes require use of a dram air gap be-

tween an undercounter dishwasher and the drain system of the house. The air gap is usually located above the sink or on the top of the counter near the dishwasher to prevent the possibility of water backing up from the drain into the

dishwasher due to o plugged drain. The drain air gap is

NOT a part of the dishwasher and IS NOT covered by the

dishwasher warranty. The drain air gap should be kept clean to insure proper draining of the dishwasher

,.