PROBLEM
Dlshes not washlng clean
Cloudy film on glassware, etching - permanent corrosion
Dishes 6 lnterlor ot dlshwasher
Rust spots on stalnless steel
Dark spots on flatware - stalnless steel, sliver plate, or sterling
Bronze tarnish on sllverplate
CAUSED BY
Water is not hot enough
Improper loading
Spray arm or arms not rotating freely
Not enough detergent or improper
detergent
“0ld”detergent
Water pressure may be low, dishwasher is not filling properly
Too much detergent in soft water
Inadequate rinsing
Iron or manganese in water
Allowing salty or acidic foods such as
mayonnaise, vinegar, fruit juices, salad dressings, milk products to remain on flatware.
Undissolved
detergent coming in contact with flatware
Silverplate is worn off Exposed base metal takes on a bronzed hue.
SOLUTION
Water temperature should be at least 140°F (60°C). Set water heater thermostat to a higher setting. Run water at sink until hot before starting.
Make sure dishes and glassware are loaded so spray reaches all surfaces and items drain properly. Do not ov- erload. Do not nest items.
Make sure large items do not block spray from reaching detergent dispensers.
Check spray arms to make sure they turn freely after load- ing. Be sure a utensil has not prevented theirturning.
Use more dishwasher detergent. Use detergent with high-
est available phosphorus content.. especially with hard water
Use only fresh dishwasher detergent, Store tightly closed container in cool, dry place. Discard old detergent. Do not fill dispensers until ready to start dishwasher.
If water pressure is low, do not use water for other purposes while dishwasher is running (to assure correct fills).
Check for rainbow hue on glasses. A rainbow hue is the first sign of etching (corrosion of glass). Reduce the amount
of dishwasher detergent. Use a detergent with a lower phosphorus content.
If water pressure is low do not use water for other purposes
while dishwasher is running [to assure correct water fills). Make sure dishes and glassware are loaded properly to
assure adequate rinsing and draining. Do not overload.
Temporary remedy:
1.Set empty dishwasher for a “one wash” cycle
2.Start dishwasher and unlatch door to stop it when it has filled for the wash part of the cycle.
3.Add % to % cup (120 to 240 ml] of citric acid crystals
(usually available in drugstores).
4.Close and latch door to complete cycle.
Permanent solution: Install an iron or manganese filter to home water supply.
Rinse flatware that is to stand for several hours before washing (use Rinse & Hold]. Clean stained items with silver polish and
tlatware In the same sllverware basket compartment. Direct contact between these metals can cause perma- nent damage to the sliver.
Remove Spots with silver polish. Avoid spilling concentrated detergent on wet flatware.
Remove tarnish with silver polish. Have silver replated
Water left in bottom of dishwasher
Dishwasher cycle not Allow dishwasher to complete cycle completed
