Faucet Installation
Be sure there is room underneath the sink to make the needed connections. Select one of the following places to install the faucet:
NOTE: Looking at Fig. 3B, be sure the faucet base will fit flat against the surface at the selected location so the gasket will seal.
| If drilling is needed, make a | |
1 | ||
hole. Be sure to use the proper procedure for | ||
| ||
| drilling porcelain or stainless steel. Special | |
| drill bits may be needed. | |
| Place small gasket, base and large gasket (in | |
2 | ||
that order) on to the faucet stem. Next, place | ||
|
lock washer and hex nut onto faucet stud.
Fig. 3A.
3
4
5
6
Insert washer into tubing adapter. Securely tighten to faucet stud.
Feed the length of 3⁄8″ OD tube from the bottom, up through the mounting hole. Connect to the tubing adapter as shown in Fig. 3B, tightening the compression nut securely.
Remove the short shipping tube and insert the spout into the faucet body. Rotate spout into place.
Lower the faucet assembly into place. Place the mounting bracket above the lock washer. While holding the mounting bracket in place, securely tighten the hex nut.
Fig. 3B.
Safety Instructions Operating Instructions Installation
Spout
Lever
Faucet
Faucet stud
ASSEMBLED
Small gasket
Base
Large gasket
Sink
Mounting bracket
Lock washer
Hex nut
Plastic washer
Tubing adaptor
Compression nut
Compression nut
3/8″ tubing, (run to Filter II outlet)
9
Instructions Troubleshooting Tips
Customer Service