Whirlpool DP8700XT Series manual Connecting your portable dishwasher, Before starting

Connecting your portable dishwasher

A

special

adapter

must

be

installed

on the faucet

before

the dishwasher

can

be

connected.

Complete

instructions

and

the adapter

are packed

with

your

dishwasher.

When

moving

your

dishwasher, make

sure

the

4.

Empty

any

remaining

water

from

the

door

is

latched.

Hold

the dishwasher

at the

top

connector.

front

corners.

5.

Unplug

power

supply

cord and return

to

storage

compartment.

6. Return hoses to storage compartment.

Before starting

Run water at faucet until it is hot. Turn it off.

PULL RING

Pull hoses out of their storage compartment

on the back. LOCKING COLLAR

HOSE CONNECTOR

3.Pull down on the locking collar while lifting the hose connector onto the faucet adapter.

4.When the connector snaps into place, re- lease the locking collar.

5.Turn the hot water on slowly until it is all the way on.

6.Plug in power supply cord.

7.See pages 8 and 9 to start the dishwasher.

While dishwasher is running

You can draw water from the faucet while the

dishwasher is connected. DO NOT draw water while the dishwasher is filling or while water is being pumped out. (This helps prevent a low fill when dishwasher is filling, or mixing drain water with fresh water.)

1.Press red button on hose connector to get the water you want. (The faucet is set on hot. Adjust faucet forthe water you want.)

2.Be sure you return cold water to off, and that hot water Is full on.

When cycle is finished

Turn hot water off. (This can be done after the last rinse.]

Press the red button on the connector to re- lease the water pressure.

Lift slightly on the hose connector while pull- ing down the locking collar. Pull down on the connector.

Electrical Connection

A power supply of 120 volts, 60Hz AC only, 15 or 20 amps, is required. For your personal safety,

this appliance must be grounded. This ap- pliance is equipped with a power supply cord having a 3-prong grounding plug. To minimize

possibleshock hazard itmust be plugged into a mating 3-prong grounding type wall recepta-

cle, grounded in accordance with the National Electrical Code and local codes and ordi- nances. If a mating wall receptacle is not avail- able, it is the personal responsibility and obliga-

tion of the customer to have a properly grounded 3-prong wall receptacle installed by a aualified electrician.

DO NOT, UNDER ANY CIRCUMSTANCES, RE- MOVE THE POWER SUPPLY CORD GROUND PRONG.

Converting to built-in

Your Whirlpool Portable Dishwasher can be

converted to a built-in (undercounter] model by using conversion kit No. 569056. The kit is

available at your Whirlpool dealer or autho-

rized TECH-CARE” Service Company. Instruc- tions are included with the kit.

Caring for

simulated wood top

The simulated wood top can be used as a utility work surface for most kitchen jobs. It is

stronger and			more		easily		cleaned		than	genu-
ine wood.
The top can be used as a cutting board. Knife
marks	will		be	visible		but		will	not seriously
damage	top.			Hot	items		from	the	oven	can be
placed	on	the		top.
Clean with warm, soapy water. For dried-on
foods,	use	a	scouring			pad.				15