Using | DEW |
| START |
|
|
| 4. | Close | and | latch | the | door. |
|
|
| |||||
1. | Push desired | Cycle | Selector | Button. |
| NOTE : |
|
|
|
|
|
|
|
| ||||||
2. | Push desired | Option | Selector | Button(s). |
| l | You can add items | while | time | is | counting | |||||||||
3. Turn Control | Knob | clockwise | to the | number of |
| down. | Close | and | latch | the | door. | The | timer will | |||||||
| hours | (from | 1 to | 4 | hours) | you | want | the | dish- |
| not advance | if the door | is unlatched. |
| ||||||
| washer | to | delay | before | the | selected | cycle | l | RINSE & HOLD and | LOW ENERGY WASH Cycles | ||||||||||
| starts. |
|
|
|
|
|
|
|
|
|
| cannot | be | delayed. |
|
|
|
|
| |
| :- | _ | .; : | I / Fli” |
|
|
|
|
|
Changing a setting
You can change a setting anytime during any cycle.
1.Lift up on the door latch to stop the cycle. Don’t open the door until the spray arms stop spinning.
2.Turn the Cycle Control Knob clockwise to the cycle you want.
3.Be sure the detergent dispensers are filled properly for the new cycle.
4.Press door firmly to latch it. The dishwasher
will automatically start the new cycle.
The CLEAN Signal Light
The CLEAN Signal Light will come on when a washing cycle is complete.
To add a dish after starting
1.To be sure the added item is washed and rinsed, make sure the Cycle Control Knob has not passed LOW ENERGY WASH.
2.Lift up on the door latch to unlatch the door and to stop the cycle. Don’t open the door until the spray arms stop spinning.
To turn light off, turn the Control Knob clock- wise slightly until the light goes off.
3.Open the door and add the dish.
4.Close the door. Do not latch it. Wait 30 sec- onds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle.
5.Press door firmly to latch it. The dishwasher will start from where it stopped.
10