Whirlpool DP3801XL, DU3003XL When cycle is finished, Before starting, While dishwasher is running

r -~ ------ ----- - -

A special adapter must be installed on the faucet before the dishwasher can

be connected. Complete Instructions and the adapter are packed wlth your dlshwasher.

When moving your dishwasher, make sure the door is latched. Use the built-In pull bar or hold it at the top front corners.

3.Llft slightly on the hose connector while puil- ing down the locking collar. Pull down on the connector.

4.Empty any remaining water from the connector.

5.Unplug power supply cord and return to storage compartment.

6.Return hoses to storage compartment.

Before starting

1. Run water at faucet until it is hot. Turn it off.

PULL RING

2.Pull hoses out of their storaae compartment on the back.

CKING COLLAR

3.Pull down on the locking collar while lifting the hose connector onto the faucet adapter.

4.When the connector snaps into place, re- lease the locking collar.

5.Turn the hot water on slowly until it is all the way on.

6.Plug in power supply cord.

7.See pages 8 and 9 to start the dishwasher.

While dishwasher is running

You can draw water from the faucet while the

dishwasher is connected. DO NOT draw water while the dishwasher is filling or while water is being pumped out. (This helps prevent a low fill when dishwasher is filling, or mixing drain water with fresh water,]

1.Press red button on hose connector to get the water you want. (The faucet is set on hot. Adjust faucet forthe water you want.)

2.Be sure you return cold water to off, and that hot water Is tull on.

When cycle is finished

1.Turn hot water off. (This can be done after the last rinse.)

2.Press the red button on the connector to re- lease the water pressure.

Electrical Connection

A power supply of 120 volts, 60Hz AC only, 15 amps, is required. For your personal safety, this

appliance must be grounded. This appliance

is equipped with a power supply cord having a 3-prong grounding plug. To minimize possi- ble shock hazard it must be plugged into a mating 3-prong grounding type wail recepta-

cle, grounded in accordance with the Na- tional Electrical Code and local codes and

ordinances. If a mating wall receptacle is not

available, it is the personal responsibility and

obligation of the customer to have a properly

grounded 3-prong wail receptacle installed

by a qualified electrician. DO NOT use an ex-

tensionggy

DO NOT, UNDER ANY CIRCUMSTANCES, RE- MOVE THE POWER SUPPLY CORD GROUND PRONG.

Converting to built-in

Your Whirlpool Portable Dishwasher can be

converted to a built-in (undercounter) model by using conversion kit No. 569056. The kit is

available at your Whirlpool dealer or autho- rized TECH-CARE@ Service Company. Instruc- tions are included with the kit.

Caring for

simulated wood top

The simulated wood top can be used as a utility work surface for most kitchen jobs. it is stronger and more easily cleaned than genu- ine wood.

The top can be used as a cutting board. Knife marks will be visible but will not seriously dam- age top. Hot items from the oven can be placed on the top.

Clean with warm, soapy water. For dried on foods, use a scouring pad.

14