Connecting your portable dishwasher
|
| A | special | adapter | must | be installed | on | the | faucet | before | the dishwasher | can |
|
| ||||||
| be | connected. | Complete | instructions | and | the adapter | are | packed | with | your |
|
| ||||||||
| dishwasher |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
When | moving | your dishwasher, | make | sure |
|
| ing | down | the |
| locking | collar. | Pull | down | on | |||||
the | door | is latched | Use the | pull | bar or |
|
| the | connector. |
|
|
|
|
|
| |||||
hold | it at | the | top | front | corners. |
|
|
|
| 4. | Empty | any | remaining | water | from | the | ||||
|
|
|
|
|
|
|
|
|
|
| connector. |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
| 5. | Unplug |
| power |
| supply | cord | and | return | to | |
|
|
|
|
|
|
|
|
|
|
| storage |
| compartment. |
|
|
|
| |||
|
|
|
|
|
|
|
|
|
| 6 | Return | hoses | to | storage | compartment. |
| ||||
Before starting”’
1. Run water at faucet until it is hot. Turn It off
PULL RING
2.Pull hoses out of their storage compartment on the back.
LOCKING COLL AR
TOR
3.Pull down on the locking collar while lifting the hose connector onto the faucet adapter.
4.When the connector snaps into place, re- lease the locking collar.
5.Turn the hot water on slowly until it is all the way on.
6.Plug in power supply cord
7.See pages 8 and 9 to start the dishwasher.
While dishwasher is running
You can draw water from the faucet while the
dishwasher is connected. DO NOT draw wafer while the dishwasher is filling or while water is being pumped out. (This helps prevent a low fill when dishwasher is filling, or mixing drain water with fresh water.]
1.Press red button on hose connector to get the water you want. (The faucet is set on hot. Adjust faucet for the water you want.)
2.Be sure You return cold water to off, and that hot water Is full on.
When cycle is finished
1.Turn hot water off. (This can be done afterthe last rinse.]
2.Press the red button on the connector to re- lease the water pressure.
3.Lift slightly on the hose connector while pull-
Electrical Connection
A power supply of 120 volts, 60Hz AC only, 15 amps, is required For your personal safety, this
appliance must be grounded. This appliance
is equipped with a power supply cord having a
cle, grounded in accordance with the Na- tional Electrical Code and local codes and
ordinances. If a mating wall receptacle is not
available, it is the personal responsibility and
obligation of the customer to have a properly
grounded
Power Supply Cord
DO NOT, UNDER ANY CIRCUMSTANCES, RE- MOVE THE POWER SUPPLY CORD GROUND PRONG.
Converting to built-in
Your Whirlpool Portable Dishwasher can be
converted to a
available at your Whirlpool dealer or autho-
rized
Caring for
simulated wood top
The simulated wood top can be used as a utility work surface for most kitchen jobs. It is stronger and more easily cleaned than genu- ine wood.
The top can be used as a cutting board. Knife marks will be visible but will not seriously dam- age top. Hot items from the oven can be placed on the top.
Clean with warm, soapy water. For dried on foods, use a scouring pad.
