Operating Instructions
Continued
Startingyour dishwasher
1. Push a Cycle Selector Button for the desired cycle. Normal Wash, Low Energy Wash and Rinse & Hold Cycles share the same button. The Cycle Control Knob determines which cycle operates.
2. Push an Option Selector Button for each desired option. (Use Air Dry Option for Rinse & Hold Cycle.)
3. Turn the Cycle Control Knob clockwise to point to a desired cycle. You will feel a definite stop at each cycle mark. The dishwasher will automatically start that cycle.
NOTE: If the door is latched, you will hear cycles start and stop as the knob passes each cycle mark. This is normal and will not hurt the dish- washer. If you prefer, you can set cycles with the door unlatched.
Toadda dish after starting
1. To be sure the added item is washed and rrnsed, make sure the Cycle Control Knob has not passed LOW ENERGY WASH.
2. Lift up on the door latch to unlatch door and stop the cycle. Don’t open the door until the spray arms stop spinning.
3. Open the door and add the dish.
4. Close the door. Do not latch it. Wait 30 sec- onds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle.
5. Press door firmly to latch it. The dishwasher will automatically start where It stopped.
Changinga cyclesetting
You can change a setting anytime during any cycle.
1. Lift up on the door latch to unlatch the door and stop the cycle. Don’t open the door until the spray arms stop spinning.
2. Turn the Cycle Control Knob clockwise to the cycle you want.
3. Be sure the detergent dispensers are filled properly for the new cycle.
4. Push door firmly to latch It. The dishwasher will automatrcally start the new cycle.
Changingan option
If you want to change a selected option, push the RESET OPTIONS Button.
