English
ACCESSORIES
Recommended accessories for use with your tool are available for purchase from your local dealer or authorized service center.
WARNING: Since accessories, other than those offered by DEWALT, have not been tested with this product, use of such accessories with this tool could be hazardous. To reduce the risk of injury, only DEWALT, recommended accessories should be used with this product.
Bench Mounting
Holes are provided in all four feet to facilitate bench mounting, as shown in Figure 2. (Two different sized holes are provided to accommodate different sizes of screws. Use either hole, it is not necessary to use both.) Always mount your saw firmly to prevent movement. To enhance the tool’s portability, it can be mounted to a piece of 1/2" (12.7 mm) or thicker plywood which can then be clamped to your work support or moved to other job sites and reclamped.
NOTE: If you elect to mount your saw to a piece of plywood, make sure that the mounting screws don’t protrude from the bottom of the wood. The plywood must sit flush on the work support. When clamping the saw to any work surface, clamp only on the clamping bosses where the mounting screw holes are located. Clamping at any other point will surely inter- fere with the proper operation of the saw.
IMPORTANT SAFETY INSTRUCTIONS
Changing or Installing a New Saw Blade (Fig. 5, 6)
WARNING: Turn off tool and disconnect from power source before attempting to move it, changing accessories or making any adjustments accept as written in laser adjustment instructions.
CAUTION:
•Never depress the spindle lock button while the blade is under power or coasting.
•Do not cut ferrous metal (containing iron or steel) or masonry or fiber cement product with this miter saw.
Removing the Blade
1.Unplug the saw.
2.Raise the arm to the upper position and raise the lower guard as far as possible.
3.Loosen, but do not remove guard bracket screw until the bracket can be raised far enough to access the blade screw. Lower guard will remain raised due to the position of the guard bracket screw.
4.Depress the spindle lock button (Fig. 3) while carefully rotating the saw blade by hand until the lock engages.
FIG. 2
LEFT SIDE FENCE
CLAMPING KNOB
BENCH
MOUNTING
HOLES
WRENCH
HOLES FOR
EXTENSION KIT
OPERATING
HANDLE
GUARD
RIGHT SIDE
FENCE
TABLE
MITER LOCK
LEVER
MITER SCALE
BASE
| TRIGGER | |
FIG. 3 | SWITCH | |
MOTOR | ||
| ||
| END CAP | |
| SPINDLE LOCK | |
| BUTTON | |
| MOTOR | |
| HOUSING |
LEFT SIDE
FENCE
MITER | MITER | |
DETENT | ||
SCALE | ||
MITER | ||
DETENT | HAND | |
OVER RIDE | ||
INDENTATION | ||
|
CARRYING
HANDLE
DUST
SPOUT
BEVEL CLAMP KNOB
BEVEL
SCALE
5
