English
INSIDE CORNER:
Left side
1.Miter right at 45°
2.Save the right side of cut Right side
1.Miter left at 45°
2.Save left side of cut
OUTSIDE CORNER:
Left side
1.Miter left at 45°
2.Save right side of cut
Right side
1.Miter right at 45°
2.Save left side of cut
Special Cuts
NEVER MAKE ANY CUT UNLESS THE MATERIAL IS SECURED ON THE TABLE AND AGAINST THE FENCE.
ALUMINUM CUTTING
Certain workpieces, due to their size, shape or surface finish, may require the use of a clamp or fixture to prevent movement during the cut. Position the material so that you will be cutting the thinnest cross section, as shown in Figure 31. Figure 32 illustrates the wrong way to cut these extrusions. Use a stick wax cutting lubricant when cutting aluminum. Apply the stick wax directly to the saw blade before cutting. Never apply stick wax to a moving blade.
The wax, available at most hardware stores and industrial mill supply houses, provides proper lubrication and keeps chips from adhering to the blade.
Be sure to properly secure workpiece. Refer to page 4 for correct saw blade.
BOWED MATERIAL
When cutting bowed material always position it as shown in Figure 33 and never like that shown in Figure 34. Positioning the material incorrectly will cause it to pinch the blade near the completion of the cut.
Cutting Plastic Pipe or Other Round Material
Plastic pipe can be easily cut with your saw. It should be cut just like wood and CLAMPED OR HELD FIRMLY TO THE FENCE TO KEEP IT FROM ROLLING. This is extremely important when making angle cuts.
CUTTING LARGE MATERIAL
Occasionally you will encounter a piece of wood a little too large to fit beneath the blade guard. A little extra height can be gained by rolling the guard up out of the way, as shown in Figure 28. Avoid doing this as much as possible, but if need be, the saw will operate properly and make the bigger cut. NEVER TIE, TAPE, OR OTHERWISE HOLD THE GUARD OPEN WHEN OPERATING THIS SAW.
FIG. 29
FENCE
TABLE
CROWN MOLDING FLAT ON TABLE
AND AGAINST FENCE
FIG. 30
BOTTOM SIDE |
|
OF MOLDING | DW 7084 CROWN |
| |
TOP SIDE | MOLDING FENCE |
| |
OF MOLDING | TABLE |
| |
FENCE |
|
CROWN MOLDING BETWEEN FENCE AND TABLE
FIG. 33 |
| FENCE | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
CORRECT
FIG. 31
BLADE
FENCERIGHT
FIG. 32
| BLADE |
FENCE | WRONG |
|
FIG. 34
INCORRECT
13
