Before starting your dishwa .sher,
1. Read “Important Safety Instructions” on page
2 before starting your dishwasher.
(~~‘1’1’1’1’1’1’1’11’1111111111111
2. Spin the Upper and Lower Spray Arms to make sure nothing will stop them from turning freely.
3. Push door firmly when closing and it will auto- matically latch.
4. Run hot water at sink nearest dishwasher until it is hot. Turn it off.
Starting your dishwasher
1.Push a Clean Selector Button for the desired cycle.
2.Push Option Selector Button for desired option or options. (Use AIR DRY for RINSE & HOLD Cycle.]
3.Turn Cycle Control Knob clockwise to point to a desired cycle.You will feel a definite stop at each cycle mark.
CLEAN SELECTOR BUllONS | OPTION SELECTC |
tor Button determines which cycle it operates.
-NORMAL WASH, LOW ENERGY WASH and RINSE & HOLD Cycles share the NORMAL WASH Clean Selector Button. The Cycle Control Knob setting determines which cy- cle will operate.
The dishwasher will automatically start the selected cycle.
The AIR DRY Option
Air in the dishwasher is automatically heated during the “dry” pari of all cycles.
If the AIR DRY Option is selected, air in the dishwasher is not heated. Using this option helps save energy, but dishes take longer to dry (over-
night] and some water spotting may result. Some items (such as plastics) may need towel drying.
For best results, use a liquid rinse aid such as
HI-TEMP WASHING Option
When this option is selected, water for the main wash and the final rinse is heated (except in RINSE & HOLD] to 145°F (63°C). Washing and rinsing action in those parts of the cycle will be longer if the water is heated.
If water is already hot enough, the cycle continues without delay. The WATER HEATING HOLD Signal Light will be on while the cycle delays for water heating.
Changing a setting
You can change a setting anytime during any cycle.
1.Lift up on the door latch to unlatch the door and stop the cycle. Don’t open the door until the spray arms stop spinning.
2.Turn the Cycle Control Knob clockwise to the cycle you want.
To add a dish after starting
1.To be sure the added item is washed and rinsed, make sure the ADD A DISH Signal Light is ON.
2.Lift up on the door latch to unlatch the door and stop the cycle. Don’t open the door until the spray arms stop spinning.
3.Open the door and add the dish.
8
3.Be sure the detergent dispensers are filled properly for the new cycle.
4.Press door firmly to latch it. The dishwasher
will automatically start the new cycle.
4.Close the door. Do not latch it. Wait 30 sec- onds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle.
5.Latch the door. The dishwasher will start from where it stopped.
