Whirlpool ECKMF-28 manual STEP A10

NOTE. GREEN

WIRE MUST BE

STEP A10

ROTATE CLIPS

AlO. Connect Ice Maker to wiring assembly. Place the ice maker on the side of the freezer so:

1.Wiring lays between shield and Ice Maker.

2.Plug is flat against the shield.

3.Wiring is above the bracket on the back of Ice Maker.

WARNING-DO NOT PINCH WIRES BETWEEN BRACKETAND SIDE OFFREEZER.

Al 1. Put screw (#489069) through bottom bracket and into freezer wall, then turn the 2 top clips down (Step A5). Tighten all 3 screws.

TIGHTEN SCREWS

A12. Place ice bucket under Ice Maker.

\	SCREW
\	Y‘w9069
BRACKET	STEPAll -STEPA

B.INSTALLING WATER LINE AND WIRING ON BACKOF CABINET

Bl. Place clamp (#488878) over spout of water tube fitting. Put tube insert (#841707) in one end of tubing that has been soaking in hot water. Put tube insert and end of tubing into spout. Tighten clamp with screw (#488645).

B2. Slide 2 clamps (#488366) over tubing. Remove the screw from cabinet and attach upper clamp to cabinet with this screw. Use screw (#488645) from kit to attach lower clamp to cabinet. Hold wires away from screw when tightening.

CLAMP	Y4a8816	CLAMPS
(WITH	SCREW Y4.38645)
		-48

(FEEDS UNDER WIRING ASSEMBLY