Whirlpool ECKMF-64 2Remove Plu s And- Cover From B reezer, CONNECTING ICE MAKER 76 FREEZER WALL

CONNECTING ICE MAKER 76 FREEZER WALL

2Remove Plu s And- Cover From B reezer

REMOVE i PLUGS FROM SQUARE

HOLES (1SEE ARROWS).

SNAP SCREW

GROMMET #3(Parl No. 502037)

INTO PLACE IN BOTTOM

SQUARE HOLE

\

6Insert Sliding Adapt= Plug Into Rear of Ice

Maker -REMOVE KNOCK-OUT FROM END OR SIDE POSITIONS AS INDICATED.

TOP AND	SIDE-BY-SIDE
BOmOM MOUNl	FREEZER
FREEZER	MODELS
TJMODELS

PLUG-IN CONNECTOR

TO RECEPTACLE ON

FOR TOP AND BOlTOM MOUNT FREEZER

SLIP TUBE

#l (Part No 636490) OViR WATER INLEi

TUBE-PUSH ON.

FOR SIDE-BY-SIDE

FREEZER

SLIPTUBE #l (Part No. 636175)

OVER WATER

INLET TUBE-ENGAGE FIRMLY CURVED END TO

POINT TOWARD CENTER OF FREEZER

ICE MAKER

4Install W‘ater Fill Tubr Grommet

TOP AND BOTTOM	SIDE-BY-SIDE -
MOUNT FREEZER	I FREEZER MODELS

MODELS AFTER ALUMINUM FILLTUBE IS IN PLACE, SLIDE GROMMET #2 (Parl No. 835649) OVER TUBE-

SNAP INTO PLACE.

WHILE HOLDING ICE MAKER, PUSH CLIPS THAT ARE MOUNTED ON SIDE INTO SQUARE

HOLES AND PUSH DOWN FIRMLY UNTIL ICE MAKER STOPS