Before using your refrigerator
1. Remove sales labels...
Remove the Consumer Buy Guide Label, tape and any inside labels before using the refrigera- tor. To remove any remaining glue:
1.Rub briskly with thumb to make a ball then remove.
OR
2.Soak area with liquid hand dishwashing de- tergent before removing glue as described in step 1.
DO NOT USE sharp instruments, rubbing alco-
hol, flammable fluids or abrasive cleaners. These can damage the material. See “lmpor-
tant Safety Instructions” on page 3.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR. Do not remove the Tech Sheet fastened under
the refrigerator at the front.
2. Clean it...
Clean your refrigerator before usrng It See cleaning instructions on page 9.
3. Plug it in...
TYPE WALL RECEPTACLE
4. Install properly...
1.Allow ‘1~inch (1.25 cm) space on each side ana
at the top of the refrigerator for ease of installation.
2.If the refrigerator is to be against a wall, you might want to leave extra space on the hinge side closest to the wall so the door can be opened wider.
3.The refrigerator back can be flush against the wall.
REFRIGERATOR |
|
| ||||
POWER CORD | GROUNDING | PLUG |
| |||
RECOMMENDED | GROUNDING | METHOD |
| |||
A 115 Volt, 60 | Hz., AC only 15 or 20 | ampere | fused | |||
and properly | grounded | electrical | supply | is re- | ||
quired. | It is recommended | that | a separate | circuit | ||
serving | only this appliance | be | provided. |
| ||
Do not use an extension cord. Use a recepta- cle which cannot be turned off with a switch or
pull chain. See Electrical Requirements and
Grounding Instruction Sheet in your Literature Package.
5. Level refrigerator-freezerI ...
USE SCREWDRIVER
TO ADJUST
| I |
FRONT ROLLER | I I |
VELING SCREW
/
LEFl TO LOWER
1.Remove base grille. (See page 8.1
2.To raise front, turn screw in direction shown,
3.To lower front, turn screw in direction shown,
4.Check with level.
5.Replace base grille. [See page 8.)
