Using Your Refrigerator
Continued
Removing the base grille
To remove the grille: i. Open the Coors.
2. Pull grille out as shown.
3. Do not remove Tech Sheet fastened behlnd grille.
To replace the grille:
1. Line up grille support tabs with metal clips
2. Push firmly to snap Into place.
3. Close the doors.
See cleaning instructions for defrost pan and condenser coils on page 15.
THIRST CRUSHER.” dispensing system
Personal Injury Hazard
Tumbling ice and pressure on a fragile glass can break it. Do not use a fragile glass when dispensing ice or water. Failure to do so could resuli in personal injury or breakage.
To dispense ice:
1. For cubed ice, move Ice Selector Switch to CUBE position.
For crushed ice, move Ice Selector Switch to CRUSHE:D oosltion.
2. Press a sturdy glass against the ice dispenser bar. Hold glass close to dispenser opening so ice does not fall outside of glass.
3. Remove the glass to stop dispensing.
NOTE: The first few batches of ice may have an
Ice is dispense’d from the ice maker storage bin in the freezer. When the dispenser bar is pressed, a trapdoor opens in a chute between the dis- penser and the ice bin. Ice is moved from the bin and falls through the chute. When the dispenser bar is released. a buzzing sound may be heard for a few seconds as the trapdoor closes.
The dispensing system will not operate when the freezer door is open.
NOTE: Large amounts of cubed ice should be taken from the bin, not through the dispenser.
10
