Install properly.. .
I.Allow ‘/2” (.2 cm] space on each side and at top for ease of installation.
2. The refrigerator back can be flush against the
WCIII.
3.If the refrigerator is to be against a wall, you might want to leave enough space so the door can be opened wider.
e Screwdriver
Right to Raise;
Left to lower
1.Remove base grille (see page 9 ).
2.To raise front, turn each screw to the right
3.To lower front. turn each screw to the left.
4.Check with level.
Remove sales labels.. .
Remove the Consumer Buy Guide label and other rnstde labels before using the refrigerator Any glue left can be taken off with rubbing alcohol.
Clean it.. .
Clean your refrigerator before usrng It. See clean- ing rnstructrons on page 9
t Refrigerator Power Cord
Recommended
Grounding Method
A 115 Volt, 60 Hz., AC only, 15 or 20 ampere fused electrical supply is required. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a receptacle which cannot be turned off wlth a switch or pull chain. See individual electrical requirements and
grounding instruction sheet in your literature
4
