Install urouerlv... | Remove sales labels... |
E l-
K.-
1.Allow YZinch (1.25 cm) space on each side and
at the top of the refrigerator for ease of installation.
2.If the refrigerator is to be against a wall, you might want to leave extra space so the door can be opened wider.
Remove the Consumer Buy Guide label, tape and any inside labels before using the re- frigerator. To remove any remaining glue:
1.Rub briskly with thumb to make a ball then remove.
OR
2.Soak area with liquid hand dishwashing detergent before removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTIONS LABELS INSIDE YOUR REFRIGER- ATOR.
Do not remove the Tech sheet fastened under the refrigerator at the front.
Clean it...
Clean your refriger- ator before using it.
See cleaning instruc- tions on page 9.
3.The refrigerator back can be flush against the wall.
Level refrigerator-freezer.. I .
USE SCREWDRIVER
TO ADJUST
,’
I
FRONT ROLLER | I I |
ELLING SCREW
IGHT TO RAISE;
LEFl TO LOWER
1.Remove base grille [see page 7).
2.To raise front, turn screw in direction shown.
3.To lower front, turn screw in the direction shown.
4.Check with level
Plug it in...
REFRIGERATOR |
|
| |||||
POWER CORD | GROUNDING | PLUG |
| ||||
RECOMMENDED | GROUNDING | METHOD |
| ||||
A 115 Volt, 60 Hz., AC only | 15 or 20 | ampere fused | |||||
and | properly | grounded | electrical | supply | is | ||
required. | It is recommended |
| that a separate | cir- | |||
cuit | serving | only | this appliance | be | provided. |
|
Do not use an extension cord. Use a recepta- cle which cannot be turned off with a switch or pull chain. See individual electrical requirements and grounding instruction sheet in your literature package.
4