Install properly..
ilLi ,‘A ,~I
II
Allow room to Open lid
I | I II- | |
| 3 Inches | 3 inches |
1 Check the strength of the floor. It should hold the weight of a fully loaded freezer.
2.Pick a safe place, indoors, away from in- flammables such as gasoline.
3.Allow at least 3 inches (7.5 cm] air space on all sides of freezer and 2 inches (5 cm) at back Leave room at top for lid to open all the way.
4.It should not be necessary to remove the lid during
installation. If, for any reason, the hinges need ad- justment, see your authorized WHIRLPOOL dealer.
5.Do not cover the freezer with items such as blankets, sheets, tablecloths, etc.
Remove sales labels...
Remove any labels before using the freezer.
To remove any remaining glue:
I, Rub briskly with thumb to make a ball, then remove.
OR
2.Soak area with dishwashing detergent solution (1 teaspoon detergent in 1quart warm water] before removing glue as described in step 1.
DO NOT USErubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car- bon tetrachioride, etc. These can damage the material.
NOTE: DO NOT REMOVEthe Tech Sheet on inside of compressor compartment door.
Clean it ...
Clean your freezer before using It See cleaning Instructions on page 6.
Level chest freezer...
from end to end and front to back so that the lid will Plug it in...
seal properly.
| Sprang | grounding |
Check with level | type wall | receptacle |
Retaining | Clip |
|
Freezer /
Power Plug I
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused and properly grounded electrical supply is required.
It is recommended that a separate circuit serving only this appliance be provided. Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord.
.4ttach retaining clip over power cord plug from literature package inside the freezer.
See individual electrical requirements and ground- ing instruction sheet in your literature package.
4