Before you plug it in, Install Properly l~~LJLJL

Before you plug it in

Before using your freezer, you are personally responsible for making sure that it.

l is installed and leveled on a floor that will hold the weight, and in an area suitable for its size and use.

l is connected only to the right kind of outlet, with the right electric supply and grounding (see page 3).

l is used only for jobs expected of home freezers.

l is not near an oven, radiator or other heat source

is properly maintained.

is in a dry sheltered area.

is used in an area where the room tempera- ture will not exceed 110,F (43.3-C).

is not run where there are explosive fumes.

is not used by children or others who may not understand how it should be used.

is not loaded with food before it has time to get properly cold.

--l~~LJLJL

’	AllcLroo%	open’lid	~	’	~	I
I	+w		2 inches		at back

1.Check the strength of the floor. It should hold weight of fully loaded freezer.

2.Allow at least 3 inches (7.5 cm] air space on sides of freezer and 2 inches (5 cm) at back. Leave room at top for lid to open all the way.

3.If lid needs to be removed to get freezer through the doorway, follow these steps:

. l Check the way the lid sits on the cabinet to help when replacing.

l With lid closed, remove hinge screws from the cabinet.

lLift off lid.

To replace:

l Place lid on cabinet.

l Replace hinge screws. Check to be sure lid gasket is making contact with cabinet on all four sides.

4.Do not cover the freezer with items such as blankets, sheets, tablecloths, etc.

from end to end and front to back so that the lid will seal properly.

Check with lev

Remove the Consumer Buy Guide label before

using the freezer. Remove any left over glue with

rubbing alcohol.

Note: DO NOT REMOVE the Care and Ser- vice label on the inside lid. This permanent

label provides immediate information should it be needed. Do not remove Tech

Sheet permanently attached to back of cabinet.

Clean your freezer before using it. See clean- ing instructions on page 4.