Plug It In...
Freezer power cord
Recommended Grounding Method
A 120 Volt, 60 Hz., AC only, 15 ampere fused electrical supply is required. It is recommended that a separate circuit serving only this appli-
ance be provided. The receptacle should not be controlled by a wall switch or pull chain.
Attach retaining clip over power cord plug
from the literature package inside your freezer. Do not use an extension cord.
Using your freezer
Adjusting Cold Control...
l Turn control to higher number for colder temperatures.
l Turn to lower number for less cold temperatures.
Setting the Cold Control...
1.Insert a coin in the slot of the Cold Control to turn it.
2.Turn control to Number 3. This setting will main-
tain zero zone temperatures under normal op- erating conditions.
Cooling Freezer First...
l Allow freezer to cool 6 to B hours before filling with frozen food.
l Let it cool overnight before adding large amount of unfrozen food.
Note: When | freezer | is first started | the | compressor |
| ||||
will | run constantly | until the | cabinet | is | cooled. | It | |||
may | take | up | to 6 to | B hours | or longer, | depending |
| ||
on | room | temperature | and | the | number | of times |
| ||
the freezer lid is opened.
After the cabinet is cooled the compressor will turn on and off as needed to keep freezer at proper temperature.
The outside of your freezer may feel warm. This is normal. The freezer’s design and main function is to remove heat from packages and air space inside the freezer. This heat is transferred to the room air so the walls of the freezer may be warm.
Exterior Signal light...
automatically warns of any unexpected power failure.
Signal light cover
If the signal light is not glowing, immediately check:
0 for power interruption,
l the power plug; it may be disconnected from the outlet,
l the warning light; it may be burned out.
To replace burned out signal light:
1.Unplug power cord from outlet.
2.Carefully snap out light cover and assembly
with a screwdriver by inserting it under the end of metal edge of the light. Be careful not to chip finish on freezer.
3.Unplug burned out signal light and replace with a new one. Signal light can be ordered from your Whirlpool dealer.
4.Then, snap light assembly into place.
5.Plug cord into outlet.
3
