Whirlpool EH120F Using your, Setting the temperature control, Cooling freezer first, Signal light

Using your		freezer
.*~~ypsesa*...&.*~*+e,I!<?&‘2Jsi.i‘::“.-:s;,i?..‘r@C. ,:.
Setting the temperature control...
I. Insert a corn rn the slot of the Temperature Control to			1 Turn control to higher number for colder temper-
			atures.
turn it.
2. Turn control to Number		3 This setting is desrgned to	2 Turn to	lower	number for		less cold temperatures.
matntarn the	temperature at or near 0°F ( -- 17.8%)		Cooling freezer first...
under normal	operating	conditions	1 Allow freezer to cool 6 to 8 hours before filling with
			frozen	food.
			2 Let it cool overnight before adding large amount
			of unfrozen		tood.
			NOTE: When freezer is first started the compressor will
			run constantly until			the cabinet	is cooled. It may take
			up to 6 to 8 hours or longer, depending on room tem-
			perature and the number of times the freezer lid is
			opened
			After the	cabinet		is cooled	the compressor will turn
			on and off as needed to keep freezer at proper
			temperature.

The sliding basket...

Can be moved from side to stde or removed when loadrng or unloading food below it

To remove:

Lift baskei out

To replace:

Lower basket Into place

The key eject lock...

cun

help

reduce

the hazard

of child

To lock

or

unlock

the

freezer

you

must

hold the

entrapment

s.--.--

key

In

the

lock

while

turnrng

The

lock

is sprrrlg

loaded so the key cannot be left in the lock.

If

the key

IS lost,

contact

your

WHIRLPOOL

dealer

for

a replacement

Always give the com-

plete model and serial number of your freezer

-x

when

requesting

a

replacement

key.

-.,

The signal light...

automatically warns of any unexpected power failure.

If the signal light is not glowing, immediately check: l for power interruption,

l for an unplugged power cord,

To replace:

1.Unplug power cord from outlet.

2.Carefully snap out light cover and assembly with a screwdriver by inserting it under the end of metal edge of the light. Be careful not to chip finish on freezer.

3.Unplug burned out signal light and replace with a new one. Signal light can be ordered from your WHIRLPOOL dealer

4.Then, snap light assembly into place.

5.Plug power cord into outlet.

Signal light