Install properly..
II | DD | 111 |
I | ||
I | I&l |
|
Allow room to open lid
/;inches 3inchesfr
I, Check the strength of the floor. It should hold the weight of a fully loaded freezer.
2.Pick a safe place, indoors, away from in- ftammabies such as gasoline.
3.Allow at least 3 inches (7.5 cm) air space on all sides of freezer and 2 inches (5 cm] at back. Leave roam at top for lid to open all the way.
4.It should not be necessary to remove the lid during installation. If, for any reason, the hinges need ad- justment, see your authorized WHIRLPOOL dealer.
5.Do not cover the freezer with items such as blank&s, sheets, tablecloths, etc.
Remove sales labels...
Remove the Consumer Buy Guide label and any inside labels before using the freezer
To remove any remaining glue:
1.Rub briskly with thumb to make a ball, then remove.
OR
2.Soak area with dishwashing detergent solution (1 teaspoon detergent in 1 quart warm water) be- fore removing glue as described in step 1.
DO NOT USErubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car- bon tetrachioride, etc. These can damage the material.
NOTE: DO NOT REMOVEthe Care b Service label on inslde ild or Tech Sheet on back of cabinet.
Clean it ...
Clean your freezer befo using it. See cleaning instructions on page 6.
Level chest freezel;..
from end to end and front to back so that the lid will seal properly
Check with level
Install defrost drain covel;..
I. Remove cover from literature package.
2.Check drawing on front cover for placement.
3.Install cover
Plug- it in...
Retainipg Clip | |
|
Freezer /
Power Plug I
*‘I”“’
Recommended Grounding Method
A 115 Volt, 60 Hz.. AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate circuit serving only
this appliance be provided. Use a receptacle which cannot be turned off wtth a swlfch or pull chain. Do not use an exfenslon cord.
Attach retaining clip over power cord plug from literature package inside the freezer.
4
